Brake lights only come on when you press the pedal. The brake light is either a different bulb or filament in a dual-filament bulb than the tail light.
The brake lights won't turn off because the brake light switch on the pedestal of the brake pedal needs to be replaced.
howtochange the dashboard blubs
When break lights do not turn off when the brake pedal is fully retracted suggests two possible causes: * The brake light switch is out of adjustment and needs to be adjusted. * The brake light switch is defective and needs to be replaced.
The brake light sensor on a 1998 Nissan Quest is typically located on the brake pedal assembly. It is a switch that activates when the brake pedal is pressed, sending a signal to turn on the brake lights. To access it, you may need to remove the cover under the dashboard near the brake pedal. If you're having trouble locating it, consulting a repair manual specific to your vehicle model can provide detailed guidance.
the turn signal switch is probably bad
* It could be a blown fuse or * the brake light switch on top of the brake pedal under the dash is bad or * the turn signal switch is bad.
No , the rear brake lights do not turn on when you use your parking brake , just the brake light on your dash is supposed to come on
after i changed the battery in my Nissan quest 1997, the alarm system stay on and do not let me statr it? What can i do ?
Some are accessable from the trunk. If not, take the light assy off.
In many cases, the brake light and the turn signal use the same bulb.
If it is a single bulb, it is probably the bulb. Many tail light bulbs have two separate filaments, with the turn/brake being much brighter than the marker light. The tail light and turn/brake circuits are completely separate.
Bulb is out.