0
What else can I help you with?
How do you reset the low tire pressure light on a 2001 Oldsmobile?
on the drivers side there is a fuse panel on the dash. there you need to press the reset button once and then your change oil light will blink. then you want to press it again and the low tire pressure light will blink hold the reset button until it beeps and then let go and then press the reset button again and the light should disappear. Hope this helps!
Which is the best way to utilize anti-lock brakes?
Press brakes with firm, hard pressure.
Is the best way to utilize anti-lock brakes?
Press brakes with firm, hard pressure.
Why does the rear light failure warning light come on when you press the brakes?
You have a wiring issue or a bad brake light bulb.
Why might you hear air sounds when you press the brakes?
pressure through the lines try bleeding your brakes if your not sure how take it to a mechanic they will know how to and im sure they do it for under 80 bucks
1988 Honda Accord brake pedal too low?
Its becaue the slave cylinder is has a leak, and pressure is lost when you press on the brakes.
Tail and Interior lights don't function when you switch them on and only when you press your brakes or reverse do they function where can the problem be?
you have a short in light switch replace light switch
How do i find out what the check engine light is on for on a BMW?
first you nee to check and see if your car is referred to as OBDI or OBDII if its ODBI then you start with the car off.. turn the key to run but do not start the engine.. at this point you have less that 5 seconds to push the gas pedall all the way to the floor and press the overdrive button five times... then the check engine light will stay on.. and then blink... next its going to blink out the code for you for ex. blink-pause-blink blink-pause blink blink blink-pause blink n that would mean the problem code is 1231 just Google BMW problem codes and use that dcode to find out what the issue is..
How do i change the code on youniverse safe?
To change the code on Youniverse safe, press the enter key on the display screen. Red light will blink and the current code will be displayed. Input the new code and press enter.
How do a program the garage opener on a GM car?
To program the garage opener in a GM car, first ensure the vehicle is in park and turn on the ignition. Press and hold the two outer buttons on the HomeLink system until the indicator light changes from a slow blink to a rapid blink. Next, hold the garage door opener remote close to the HomeLink buttons and press the button you wish to program until the HomeLink light blinks slowly and then changes to a steady light. Finally, press the programmed HomeLink button to test the operation of your garage door.
How do you reset tire pressure light on Toyota 2005 highlander?
There is a button under the steering wheel press it in for about 5 seconds and the light will go out. Then your tire pressure is low it will light again check your tire pressure inflate then push the button again.
What if your service traction system light ABS light Traff off light keep coming on and at the same time there is resistance when you press the brakes you have a 2004 Pontiac grandprix?
Might be a bad wheel bearing assembly
