0
A 95 Mazda Protege will shut off during acceleration if the air and fuel mixture is drastically incorrect. A vacuum leak or fuel flow restrictions can both cause this problem.
What else can I help you with?
How do I get my lug studs off a 1999 mazda protege dx?
You can use the end of the tire iron to remove the lug bolts off a 1999 Mazda Protege DX.
What tools do you need to take off the distributor cap off an 1994 Mazda Protege?
The only tool that is really needed to remove the distributer cap off of 1994 Mazda Protege is a screwdriver. Using this tool will enable you to loosen the cap, and then you can remove it.
Where do you top off antifreeze in a Mazda Protege?
just take it to the top it has and over fill bottel
Where is the cadalydic converter on a Mazda Protege?
It is connected to the pipe off the exhaust manifold in the bottom outside of the car.
Does the check engine light on a 1998 Mazda Protege have a fuse?
It is run off of the same fuse as the engine computer.
Mazda protege brake lights turn on and off periodically?
Without more information, it may be because of your foot.
Why my 99 Mazda protege cuts of when it gets hot then it starts when it cools off Its not overheating?
could be fuel pump
How do you fix a horn that won't stop going off in a 1997 Mazda Protege?
if your horn wont go off its a short to power or faulty conector
Where is the location of the safety fuel shut off on a 1991 Mazda mx6?
The safety fuel shut off location on a 1991 Mazda MX6 is under the dash. It is on the far right side in front of the passenger seat.
How do you release tension on the power steering belt in order to change it on a 1994 Mazda Protege?
i need to change my alternator belt and don't know where the tension wheel is so i can take off the other belt to replace the alternator belt on my 94 Mazda protege 1.6l
Where do you connect the wiring harness which comes off the horn in a 1994 Mazda Protege?
Under passenger headlight behind front bumper.
Hold light blinking Mazda Protege?
To check the hold light blinking of a Mazda Protege, take off the plastic over the shifter tube or bar. Then take off the console below it and look at the wires that come up from the hollow center of the tube. The edge of the shifter tube may have cut through the wire insulation.
