0
The duration the lens was left open to produce a photograph varies depending on the photographic technique and conditions used. For example, in traditional Photography, exposure times could range from fractions of a second to several hours for long exposures. In pinhole photography, exposures can last from minutes to hours, depending on the light conditions and desired effect. Without specific details about the photograph in question, it's difficult to provide an exact number of hours.
What else can I help you with?
How much co2 is produced by a light bulb left on for 35 hours?
The amount of CO2 produced would depend on the type of light bulb and its wattage. As a general estimate, an incandescent bulb (60W) would produce approximately 0.9 kg of CO2 if left on for 35 hours, while an LED bulb (10W) would produce about 0.15 kg of CO2.
How long was Apollo 11 on the moon for?
Apollo 11 spent about 21.5 hours on the Moon's surface. The lunar module landed on the Moon on July 20, 1969, and astronaut Neil Armstrong took his historic first steps about 6.5 hours later. The astronauts left the Moon's surface after a little over 21 hours and headed back to Earth.
Convex lens produces an image that is upside down and reversed from left to right?
Yes, a convex lens can produce a real inverted image that is reversed from left to right. This occurs when the object is placed beyond the focal point of the lens. The image is formed on the opposite side of the lens from the object.
How do you control hot air balloon?
Right Then Left Then Right Then Left Then Right Then Left Then Right Then Left Then Right Then Left Then Right Then Left Then Right Then Left Then Forwards
Should Rb etched on ray ban sun glasses on lens?
yes, Rb is on the left lense opposite the one that has Ray-Ban in white letters. (this is the case for my aviators where Rb is also etched on the nose pieces and on the underside of the nose bridge)
How do you change the left front turn signal bulb in a 1999 Toyota Tacoma?
At the left under the hood there is a small Phillips screw, just above the turn signal lense, remove screw. jiggle the lense and remove. careful not to break the screw holder. I found this answer by chance on the inet, it was for a forerunner and worked the same. there is a plastic stud on bottom back of lense that is held in by rubber grommet. after removing the lense the build holder twist out. lot of luck.
Where is the proper placement of a logo on a photograph?
in the top left or right corner.
How many qt of oil for a Honda 300 ATV?
It depends on if you have a dipstick or a glass lense. My Grizzly has a glass lense at the base of the engine on the left hand side. I fill it about 3 quaters of the way and i use about 3 quarts of oil.
How do you replace the front left marker light on a 2002 mercedes benz S500?
Take a Flat screwdriver or Trim tool and carefully push lense toward the back of the vehicle and pull outwards. Rear of lense springs back. #194 Bulb.
Who is in the photograph at the end of call of duty 4?
left to right : soap gaz price griggs
How much co2 is produced by a light bulb left on for 35 hours?
The amount of CO2 produced would depend on the type of light bulb and its wattage. As a general estimate, an incandescent bulb (60W) would produce approximately 0.9 kg of CO2 if left on for 35 hours, while an LED bulb (10W) would produce about 0.15 kg of CO2.
How do you replace the front turn signal bulb located on a 1999 Toyota Camry?
Open and secure the hood with the support bar. Locate the black retaining bar that secures the turn signal lense casing located directly behind and on top of the lense case. The retaining bar connects to the car body. With a flat head screw driver pop up the plastic fastener. The lense case is now loose and is connected only by two snaps. One snap is near the left center and one is on the right center. Use the screw driver to pry the lense case from the fender side while pulling the lense case straight out and towards the center of the car. Little effort is required. Be carefull with the car's finish as you pry the lense from the fender. Once the lense case is off, twist to remove the plug. Remove the bulb and replace it using bulb grease on the bulb's base to reduce moisture related problems. Reassemble the lense case by following the steps in reverse.
Where is the photograph on Big Nate Island?
The old photograph is blowing in the wind on the left side of the lighthouse at Puffin Point. Jump off the ladder to grab it. (You should take it to the Say Cheese photo shop.)
How do you change a front left blinker bulb on a 1988 Ford Taurus and could you get shocked while replacing this bulb?
Depends on which blinker you are talking about? There is the yellow one behind a clear lense and the other is behind a yello lens on the opposite side of the headlamp. If you are doing the one behind the yellow lense on the backside of the lense there is a screw on the top. Undo it and the lense can be popped out. (Make sure the hood is up when you look for the screw or you wont find it. :>) As far as getting shocked I guess anything is possible. If you are worried about it just disconnect the battery. But I wouldn't worry about it.
How Format micro sd card for samsung S85 in camera?
You click the button on the left and twist the lense. You then need to read the instructions because i have forgotten the rest... :( Sorry about the ending:'(
How many hours left for santa?
789 hours
How do I put contact lenses in my eyes?
First you want to make sure your hands are clean. Then take one Contact lense and put it between your index finger and your thumb of your right hand. Look into the mirror and open your eye with your left hand. Carefully insert the lense into your eye and close it. When you open your eye again it shoul fall into place.
