answersLogoWhite

0

Maybe. If you need to drive passive speakers, you will need an amplifier. If you have powered speakers, you might not be able to control the volume of the signal.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Oldsmobile Intrigue rear Speaker Removal Instruction?

remove the speaker covers from fear deck. remove the four screws that hold the speakers in the rear deck. four screws hold each speaker in place. unplug the wires from the connecters. if aftermarket speakers cut after plug and splice new speaker wires into existing factory wires. reverse the procedure to install new speakers.


How do you connect speakers that have an RCA cable coming out of them taken from a PC surround sound system to a surround sound receiver its a kenwood receiver with copper cable outlets?

If the speakers are not powered (they don't plug into the wall), you can cut off the RCA plug, strip back the wires to a negative and positive lead, and connect them to the speaker posts of the receiver.


How do you wire your speakers?

That depends. If they're computer speakers and all your wires are headphone-jack style, then all you do is run the headphone wire from your speakers and plug it into your computer speaker input on the sound card, or a headphone jack. If they're not computer speakers and you want to wire component speakers through your computer, you'll need a receiver to power them, speaker wire to go from your speakers to the receiver, and a cable to go from your receiver "input jack" to your computer. That cable should have a red and white RCA on one end, and a headpone jack on the other.


How do you wire stereo speaker wire to stereo plug?

in the red or white at the back of the speakers


How do you fix ipod speakers to not be on speaker mode?

lower the volume or plug in some headphones


Can I plug speakers directly into a turntable, or do I need a receiver?

Most turn tables have speaker plugs.


How do you fit the speaker cables to the head unit on a Clio?

Assuming there is 8 wires in existing Renault wiring iso speaker plug at back of radio, the two outer wires at each end of plug are for left rear and right rear speakers, tap into these wires i.e. strip the insulation back a couple of inches from the plug and join new speaker wires onto the stripped wires. If only 4 wires in existing Renault wiring iso speaker plug then buy iso speaker plug from auto factor and join existing Renault wiring on speaker plug onto new cable and join new speaker cables (the ones you are fitting) onto the outside wires at each end of the new iso plug.


How do I make my computer's sound go through the speakers but still use a headset microphone The speaker in my headset broke?

only plug in the microphone plug into your computer while still plugging in the speakers.


What can prevent the speakers from getting sound?

1. No power to speakers. 2. Bad sound card. 3. Speaker cables plug into the wrong jacks. 4. Bad speakers.


How do you connect speakers to you lap top computer?

depends on the type of connection you have. if you cant come out of the laptop any other way then plug into the headphone jack with a cable that ends in a left right rca connection (the red and white cable) and plug that into your speakers.


How can I plug in a microphone to a speaker?

To plug in a microphone to a speaker, you will need to connect the microphone's cable to the input jack on the speaker. Make sure the microphone is turned on and adjust the volume levels on both the microphone and the speaker to achieve the desired sound output.


Are there any computer speakers that offer a microphone jack on on the front on the front of the speaker?

If you would like to plug a microphone into your speakers, Logitech offers a speaker with a port for a micropholne.