A window winder is also called a window crank. These cranks are used on manual windows. Power windows use a power switch to run the window. Usually these cranks are held in place by a screw hidden behind a cap where the crank rotates, or there is a hidden clip behind where it rotates. If there is a hidden clip you will need a special tool that most mechanics will have if they are nice enough they will let you borrow it for a few minutes. Or a local parts store would sell this tool. Be careful when you use the tool those clips will fly across the parking lot and you will loose it. Try to push it behind the rotating crank slowly and cover it with your hands as you do this. It will help prevent you from losing the clip good luck.
take it to the garage
How to remove Window Winder Handles from VZ Holden Commodore
Begin by removing the inside door panel. Remove the linkage from the window winder. Remove the window winder retaining bolts. The window winder will come off.
remove the tiny C clip from under the winder 1.25 1996 N. don't rip it off like I did.
To remove the window winder on a VW Lupo, first, ensure the window is fully closed. Use a flathead screwdriver to carefully pry off the plastic cover at the base of the winder handle. Once the cover is removed, you'll find a retaining clip or screw that secures the winder; remove it using the appropriate tool. Finally, gently pull the winder off the shaft to complete the removal.
To remove the window winder from a Hilux, first, you need to carefully pry off the decorative cover or cap from the winder using a small flat tool. Once the cap is removed, you'll find a retaining screw or a small clip; remove the screw with a screwdriver or release the clip. After that, you can pull the winder straight off the splined shaft. If necessary, you may need to use a puller tool for stubborn winders.
Between the window winder and door card there should be a plastic ring about 8mm wide. Push this ring away from the end of the window winder. The windes should now slide off
Just pull it!
take it to safelite lol
With a knife. A sharp one.
There is a pillow in the middle that will be snug in the winder so that the watch will not fall out. Remove the pillow and place the watch around the pillow. The pillow will fit snug back into the watch winder with your watch on it while the watch is wound.
To remove the window winder on a 1990 Mazda Miata, first, you need to locate the retaining clip or screw that holds the winder handle in place. If there’s a clip, use a thin screwdriver to pry it off; if it’s a screw, simply unscrew it. Once the clip or screw is removed, pull the winder handle straight off the shaft. Be sure to take care not to damage the interior panel during the process.