i have dish on 110 and trying to at on 119 i bought next lnb with a spacer can you help me.
Sorry about my approximativ english.We use the term of "monopulse antenna" for an antenna dedicated to track a moving target thanks to a so called monopulse system. The principle of a monopulse system is based on the creation of a tracking signal inside the feed of the antenna which has the particularity to have a null amplitude when idealy pointed to the target and to have an increasing amplitude when depointed from the target. The more the antenna is depointed the bigger is the amplitude (around the pointed direction). A monopulse system tries continuously to cancel the amplitude of this signal. That will mean the antenna remains idealy pointed to the target. This system has really good tracking performances (when it is properly tuned) compared to more simple system like Step-Track system which just tries to maximize the fundamental signal received from the target. I am not sure I was clear.
Hi My mobile moto X model is not detecting sim card. I couldn't see network signal. What is solution ? Thanks Motorola Service
"How do you replace a factory antenna on a 2002 Toyota Sienna?" I am talking about the whole assembly. Thanks
we can offer the antenna for you.my e-mail is sale2@antetec.com you can contact me any time,thanks!
Railway signal
thanks
You cannot obtain the letter of thanks unless you were a beta tester.
== ==
i mounted my antenna in the center of the front windsheld in the flat spot by the air intake, run the cord through the firewall (make sure to go through the rubber grommet, its a pain, but if not it will eventualy cut through the antenna) after that figure out were you are going to mount the receiver and take off the center part of the dash, you will have plenty of room to feed the wire through
Go to the Linksys web site.. They alwyas have the drivers for hardware. Goodluck
Der sir hope u be fine and healty dear sir how i can share scanar on the network thanks
By remote antenna, do you mean Over The Air (OTA). For the OTA, some receivers have a coax port on the back, TV antenna, where you can connect an outside antenna. From the receiver menu, you can scan the OTA channels into the receiver once the receiver has found the OTA channels. If this is not what you are asking, please let me know. Thanks.