answersLogoWhite

0

Check for loose or corroded battery cables Check trigger wire on starter (small wire) for corrosion (common problem) Bad starter solenoid

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

1996 Saturn SL2 starting problem checked battery cables connections all good just replaced the starter when i turn the key to start all i get is one click from the starter any ideas y it wont start?

is the battery fully charged?


1991 S10 43 drags when starting replaced the starter battery cable to starter and helped for 1 day started but after dragging down the battery and got worse changed battery but still same problem?

Remove the starter and haeit checked at auto parts for amp draw Check the alternator to see if it is keeping the battery charged Check engine ignition timing may be too far advanced


94 Thunderbird starter will not turn over?

If a 94 Thunderbird starter will not turn over, the battery may be dead. The battery should be charged with jumper cables.


Why will a 1996 dodge trk not start with afully charged battery?

Is starter working?


How do you tell if it's the alternator or the starter that is bad?

Test the battery with a digital voltmeter. You should get a reading of 12.6 V if the battery is fully charged. If the battery is fully charged then you know the alternator is functioning properly and your problem is more than likely a defective starter.


How do you trip the starter solenoid on a 1994 Geo Tracker Once the car has been driven for a while then turned off the starter will not do anything Turn the key and nothing?

If the starter will not engage on a 1994 Geo Tracker, it is possible that the solenoid needs to be replaced. There could also be a loose wire on the starter solenoid. Also check that the battery is fully charged. The battery could have gone dead while it was being driven.


How do you test starter motor for fire pump disel engine?

To test the starter motor for a diesel engine fire pump, first ensure the battery is fully charged and connections are secure. Next, use a multimeter to check the voltage at the starter terminals while attempting to start the engine; it should be close to the battery voltage. If the voltage is low, inspect the battery and wiring for issues. If the voltage is adequate and the starter doesn't engage, the starter motor may be faulty and should be inspected or replaced.


99 Contour will not make a sound when key is turned New starter fuel filter and battery is charged Does this model have a starter relay and can anyone suggest a next step?

Can be a defective ignition switch which I suspect is your problem. Not the tumbler you insert the key into but the ignition switch located down under the dash behind the steering column. Can also be a loose or corroded battery cable, or the connections at the starter. There is a starter solenoid that can be bad but it is built into the starter which you replaced.


My 1977 Pontiac Firebird just has battery replaced 2 weeks ago and a new starter 3 years and now the car starter wont engage but all the instruments still work How can i fix this?

First make sure the battery is fully charged and all wiring is tight and not corroded. If all is well then remove the starter and have it bench tested at any auto parts store.


Why car has poor starting?

Check the battery and see if it is charged or needs to be changed. Check the battery cables Check the starter condition


Car sometimes clicks when turn over new stater and battery connections ok?

Starter solenoid? Battery not fully charged?


Why does your 2003 GMC envoy not crank when you turn the ignition The battery is fully charged?

Check the starter.