0
The oil drain plug for a 1997 Geo typically uses a socket size of 15mm. However, it's always a good idea to double-check with your vehicle's manual or a reliable source for confirmation, as variations can occur based on specific models or engine types. Using the correct socket size ensures a proper fit and avoids stripping the plug.
What else can I help you with?
What is the socket size for a 97 geo metro oil drain plug?
It is 17mm.
What is the socket size for a 92 Geo Metro oil drain plug?
There is a good chance that it takes a standard size socket rather than a metric socket, it was like this on my Toyota Celica. 17mm
Where is the transmission drain plug located on a 94 Geo Tracker?
where is the trany drain plug on a 1994 ttracker
Where is the drain and fill plugs for a 1998 geo metro manual transmission?
NO drain plug... the fill plug is the dipstick tube. Oops, that's the automatic. No drain plug and the fill plug is half way up and looks like a square peg
Where is the radiator drain plug on Geo Prizm?
It is just below the lower radiator hose.
How do you change the oil on a 1995 Geo Prism?
The oil on a 1995 Geo Prism is changed by placing a drain pan under the engine, removing the oil filter, unscrewing the drain plug, and allowing all the old oil to run out. A new filter is then installed, the drain plug put in, and the engine refilled with new oil.
Where is the radiator drain plug for 93 Geo Storm?
The radiator drain plug for a 1993 Geo Storm is typically located at the bottom of the radiator on the driver's side. It's a small, often plastic or metal, screw-like fitting that can be turned counterclockwise to open and drain the coolant. Make sure to have a container ready to catch the fluid when you open the plug to avoid spills. Always take precautions and allow the engine to cool before attempting to drain the radiator.
Where are the spark plugs located on a 1994 geo prizm?
AnswerThey are inside the valve cover. Looking from the front of the car you will see the spark plug wires routing from the distributor cap to each plug. To change the plugs remove the spark plug wire and use a spark plug socket attached to an extension. I recommend adding some duct tape to the socket/extension connection to prevent the socket from coming off in the valve cover.
How do you change transmission oil on a Geo Tracker?
easy take out the drain plug (lower plug) located midway through the transmission using a 3/8 drive. This will drain the tranny oil. Then break the upper plug loose and put the lower plug in and tighten. Slowly fill the tranny with 85w/90 through the upper plug until it flows out of the plug you are filling. Finally install the fill plug and tighten.
Where do you put gear lube in a 1996 Geo Metro?
there is a plug on the side of the transmission towards the drivers side of the car,a 3/8 ratchet will fit into the plug, the drain plug and fill plug are different,the drain plus has a magnet in the middle of it. it will hold just under three quarts of gear oil,i would only use synthetic to protect the transmission
Where is the fill plug for a 1990 geo storm 5 speed tranny?
The fill plug for a 1990 Geo Storm's 5-speed transmission is typically located on the side of the transmission case. You can find it near the top, allowing you to add transmission fluid without removing the entire unit. It usually requires a wrench or socket to remove, so be sure to check the owner's manual for specific details regarding the size and type of plug. Always ensure the vehicle is on a level surface when checking or filling the transmission fluid.
What is the drive axle nut size on 1993 geo prizm?
The drive axle nut size on a 1993 Geo Prizm is typically 30mm. It's important to use the correct size socket to avoid damaging the nut during removal or installation. Always consult a repair manual or reference guide for specific torque specifications when working on the axle.
