answersLogoWhite

0

Check the coil and replace if bad. Should fix the problem.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you remove crank sensor from Chevrolet astro 93?

That year did not USE a Crank sensor.


2001 Chevy astro van will not stay running when accelated replaced fuel pump replace mass air flow sensor replaced throttle position sensor crank sensor when you start it it misfires for a little bit?

probably misaligned your crank sensor.. I'm dealing with the same problem, might need to replace with new and make sure to gap properly.


Where is crank sensor on 97 Chevy astro van 4.3?

The crank position sensor On your astro is located on front of the engine on timing cover, left side. Behind the crankshaft pulley. with a connector of 3 wires.


Where is a crank sensor on a 99 Chevy Astro van?

Do you have a 4.3L with a distributor? If so, the crank sensor is in the distributor and may also be called an HEI pickup or Hall switch.


You have replaced the heads on a 1996 ford thunderbird and all other parts but it still wont crank what could be the problem?

Have you replaced the cam and/or crank sensor?


2000 astro van where is the crank shaft sensor located?

front of the engine under the crankshaft pulley


Where is the crank sensor on a 96 Chevy Astro van?

It should be at the bottom front of the engine by the timing cover.


Replaced crank shaft sensor but no fire?

Check for power to the sensor. check for power and ground to the Ignition coil. If the crank sensor is adjustable, make sure that it is set to the proper gap.


How often does the crank sensor in a tiburon have to be replaced?

Mine went at 38,000 miles, seems to be a commonly replaced part.


Should a new motor be purchased when a crank shaft sensor needs to be replaced?

no no no my crank sensor when out on my truck ar 95k now i have 125k and she is still running good


Does a 1988 cheverolet astro van have a crank sensor?

Not as such. All fuel and spark timing signals are picked up in the distributor.


You have replaced cam sensor repaired wiring still have code 41 what else can it be?

Happened to me to and need a crank sensor also!?