answersLogoWhite

0

The Chev 302 small block and the 400 small block share bell housing patterns.

So this would work allowing things like correct pilot bearings are used.

Why you change a sweet running screamer like a 302 for low rpm dog like the 400 I will never understand

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Will a 4 speed manual transmission from a 302 bolt up to a v8 400?

If your talking about the 400(m) style motor then no it won't. The 400 has the "big block" bolt pattern, you would need a 4 sp from a big block motor to fit.


Do an amc 304 and ford 302 have the same transmission bolt pattern?

no a 258 amc and ford 302 have same bolt pattern


What type of transmission fluid does a 1995 ford bronco use?

It all depends on the type of transmission the truck has, if it is manual than manual transmission fluid is used where if it is automatic, automatic transmission fluid is used Not always, my 91 302 with a 5 speed manual uses auto fluid, a lot of manuals do.


Will a Mark VIII engine-transmission work in a 1970 Mustang 302?

The answer is no. A 302 or 5.0 will NOT bolt up to a 4.6 Liter 4r70w transmission or visa versa.


Will a 4 speed manual transmission from a inline 6 bolt up to a v8 302 or a 351?

YES IT WILL THE ONE THING YOU HAVE TO WATCH OUT FOR IS IF THE 351 IS A 351C OR A 351M THESE ARE BOTH BIG BLOCK. THE 302 AND THE 351W ARE SMALL BLOCK SO YOU SHOULD HAVE NO PROBLEM BOLTING IT UP. actually the 351c is a small block and the 351m uses both the small block and big block bell housing bolt pattern


Will a 302 bolt to a bell housing and a 3 speed trans in place of the 289 in a 66 mustang?

As long as the 302 is from a similar year it will bolt right in. The only difference between the 289 and 302 is the 302 has a slightly longer stroke.


Will a 6 cylinder 3 speed bolt up to a 302 engine?

Sorry, no.


Will 302 bolt up were 4.6 was?

no, motor mounts are different as well as the transmission bell housing


What transmission would fit a 302 1978 ford ranger engine?

A 1978 Ford Ranger with a 302 engine typically uses a transmission that is compatible with the small block Ford engine. The most common options include the Ford C4 automatic transmission or the Ford Toploader four-speed manual transmission. Depending on your specific setup and preference for automatic or manual, either of these transmissions would work well with the 302 engine. Always ensure to check compatibility with your vehicle's configuration and any modifications that may have been made.


What is the point gap on a 1969 302 single point distributor?

In a 1969 Mustang , 302 with 2 barrel carburetor , the point gap is ( .017 with automatic transmission ) and ( .021 with manual transmission )


What is the dwell on a 68 mustang 302?

On a 1968 Ford Mustang 302 cubic inch V8 : point dwell ( 24 to 29 ) - with manual transmission point dwell ( 26 to 31 ) - with automatic transmission


What is this part number for d6za-6392-bl-bc-1?

Not sure about the bl, but a D6ZA-6392-BC is a manual transmission bell housing for a Mustang II with a 302 V8 with a 4 speed.