even with the tensioner loosened all the way i still cannot get the belt on. Any suggestions on how to get the belt on?
the mazda b3000 is basically a ford ranger. the 3000 designates the 3.0 v6 motor and it has a timing chain.
Serpentine belt diagran 2003 mazda 6
bad belt, bad tesionure pulley, wrong belt, stretched belt
The cost to replace a 1999 Mazda Protege serpentine belt will vary depending on the cost of parts and cost of labor. The prices for the serpentine belt start at $14.56.
This year Mazda protege does not have a serpentine belt. It has two belts, one for the alternator/water pump, and the other for the power steering and a/c.
changing serpentine belt and pulley 90' sedan deville
you start by putting the belt on from left to right.
Open the hood and look. If it has a serpentine belt there is a tensioner.
If you are hearing squeaking from your Mazda b3000 at idle it could simply be a wet belt since the squeaking goes away once you start driving. It may also be a belt getting ready to break.
Changing the serpentine belt on a 97 Mitsubishi Diamante is a fairly easy task. All you need to do is get a wrench and loosen the tension pulley and pull of the serpentine belt.
you have to take that bottom radiator hose off to replace it
When changing the serpentine belt is it important to have a diagram to make sure the remove and installation are done properly. A serpentine belt for a BMW 2001 540i can be found in the car's maintenance manual.