it doesn't hurt...but you'll also need a yellow top for deep cycle and a high output alternator to handle the load...
No thanks...I got a nice 4000 watt system.
get the 2800
First you will absolutely need an amp to power any subwoofers. Nowadays subwoofers come along with amp..& normally one 1200watt subwoofer decrease your car battery lifetime to 2-4 month
I have a 760 watt amp powering 2 10" subs and it works fine. my brother has a 1000 watt amp powering 2 12" subs and he got a capacitor. So it really depends on what amp your looking at. if the 760w you wont need one, if the 1000w i would be safe and buy a capacitor. for the 1000w amp you would only need a 1 or 2 farad capacitor.
No the Lanzar MAXP64 Max Pro 6.5-Inch 600-Watt Small-Enclosure subwoofers are very small.
A Rockford 250 watt amp would compliment a 12" Subwoofer very nicely.
A 1000 watt generator cannot run a 1500 watt ceramic heater without having problems.
Yes because the cap will store the power and give it that extra boost when need be but depending on the type of vehicle you have you might need a bigger battery
No, a 1000VA transformer is not suitable for powering a 1500 watt oven. The 1000VA transformer is rated for supplying 1000 volt-amperes, which is approximately equivalent to 800 watts. To power a 1500 watt oven, you would need a transformer rated for at least 1500VA to safely handle the load.
To calculate the breaker size for a 1500-watt 120-volt heater, use the formula: Breaker size = Power (Watts) / Volts. In this case, 1500 watts / 120 volts = 12.5 amps. Therefore, you would need a 15-amp breaker for a 1500-watt 120-volt heater to allow for a safety margin.
This is determined by how you wire your subs to your amp. If you get an amp that's bridgeable to mono, then you can wire your subs in series. You will get much more thump if you do it this way. However, make certain that your amp is bridgeable, and stable down to 2 or even 1 Ohms. Check with the dealer you buy from. When wired the way I mentioned, a 300-Watt amp will probably do nicely!
A 3000-watt amp can typically handle subwoofers with a combined RMS power rating that matches or is below its output capacity. For example, if you have dual subwoofers rated at 1500 watts RMS each, the amp can effectively power them if wired correctly. It's crucial to consider the impedance of the subs and ensure they are compatible with the amp's output configuration to avoid damaging either component. Always refer to the specific amp and sub specs for optimal matching.