0
What else can I help you with?
Can i use computer box for a ford bantam rocam 1.3. on a ford bantam rocam 1.6 engine?
The ECM (Engine Control Module) or PCM (Powertrain Control Module) may appear to look the same as others but most are programmed (Flashed) to exactly match the vehicle it is going in.
What is the torque settings for mains and big end bearing on Ford Bantam 1.3i 2003?
The year, make and engine info would help.
What are the torque settings for cylinder head bolts on Ford Bantam 1.6 2004?
Ford 1.6 Rocam Motor: 10 bolts x 40NM + 120 degrees 2 bolts x 15NM + 45 degrees
What is the torque settings on ford bantam 1.3 rocam cylinder head?
There are three progressive tightening steps when setting the torque on the cylinder head bolts on the 1987 - 1994 Ford Bantam 1.3 Rocam . The first step is 50 - 55 ft. lbs. (68 - 75 Nm). The second step is 60 - 65 ft. lbs. (81 - 88 Nm). The third and final step is 70 - 85 ft. lbs. (95 - 115 Nm)
Ford bantam 1.3i cambelt?
Ford bantam 1.3 Xl 2004 timing chain or cambel?
What is cylinder head torque for ford bantam 1300 rocam engine?
This will vary in the vehicle that is being used. Some of them will use more power than the others.
What is the torque settings on ford bantam 1.3 rocam cylinder head bolts on the 2004 model?
For the 2004 Ford Bantam 1.3 Rocam, the cylinder head bolts typically require a torque setting of 20 Nm (14.8 lb-ft) for the initial stage, followed by an additional 90 degrees for the final stage. It's essential to follow the manufacturer's specifications carefully and to ensure the bolts are tightened in the correct sequence to prevent warping or damage. Always consult the service manual for the most accurate and detailed procedure.
Do the Ford Fiesta have a timing belt?
yes all fiestas have a timing belt except,1.3 endura,1.3 and 1.6 rocam and the 2.0 st does not have a timing belt.
Where is a Ford bantam's thermostat situated?
the following is on a ford bantam 2006 Rocam: if you open the hood and stand in front of the engine, look at the the side on the right of the engine, you can see the hoses from your radiator meeting up and connecting to a black plastic fitting , that is your thermostat housing, be careful they break easily if you try and remove them. the thermostat is inside the housing, hope this helps.
Electrical diagram for ford bantam 1600 1997?
electrical problem,ford bantam 1600 1997
What is the torque settings for ford ka rocam motor?
The torque settings for the Ford Ka Rocam motor can vary depending on the specific component being serviced. For example, the cylinder head bolts typically require a torque setting of around 20 Nm (15 lb-ft) for the initial stage, followed by an additional torque of 90 degrees for the final tightening. Always refer to the vehicle's service manual for the most accurate specifications and procedures.
What are the cylinder head torque settings for a ford bantam 1300 leisure bakkie 1998?
The cylinder head torque settings are a list of parts in the torque sequence. It tells where everything is and can be found.
