According to the 2000 Mercury Sable Owner Guide : That is your check trans-axle ( transmission ) warning light that is located in the bottom / left area of your tachometer ( a problem has been detected , shifting may be restricted ) ( if warning lamp remains on , have your vehicle serviced immediately )
30mm
The trans axle is the transmission on a front wheel drive vehicle
30mm
The transaxle is the transmission on a front wheel drive car , it's bolted to the engine ( looking in the engine compartment from the front the transaxle is to the right of the engine )
The axle retainer nut is likely to be the same as on the 1998: 30mm
Bolts by the starter(2 on starter) and 5 or 6 around the transmission housing and 2 up by the front of the motor near the axle for the passenger side front wheel where you can't see them.
To remove the CV axle from the transmission on a 1991 Mercury Capri, first ensure the vehicle is securely lifted and supported. Then, remove the wheel and brake components to access the axle. Use a pry bar to gently pull the axle out of the transmission, taking care not to damage the seals or transmission case. Finally, if necessary, remove any retaining clips or bolts that may be holding the axle in place before extraction.
Alot of things can cause this as a week mount a wore out CV axle and pressure
A Nissan Altima with a cracked axle. Meaning the part that connects your tire to the transmission is broken....
It's on the top rear corner of the transmission.
To remove the CV axle from the transmission on a 1991 Mercury Capri, first ensure the car is securely lifted and supported. Begin by removing the wheel and brake components on the side of the axle you are working on. Then, use a pry bar or a large screwdriver to gently pry the CV axle out of the transmission, being careful not to damage the seals. If necessary, you may need to disconnect the lower control arm or intermediate shaft for better access.