0
What else can I help you with?
How do you loosen the tension pulley on a 2003 ford Windstar?
Hard to tell if this question is to:Release the tension on the belt for replacement, orRemove the pulley/tensioner for replacementSee "Related Questions" below for more about doing both
If the tension pulley is bad on a 91 2.2 l Corsica can one just replace the pulley or must one replace the entire assembly?
Call the parts store. They will be able to tell you if the pulley is available separately or not.
How do you replace idler pulley 1996 ranger 3.0?
The bolt on the idler pull loosens the normal direction, lefty loosey on the ford ranger 3.0 engine. If you look lower, you'll notice the tension pulley. You can tell it's the tension pulley by the pivoter arm that it's bolted to. Take the proper size wrench or socket, and turn clockwise as if you were to tighten it. It takes a little bit of force, but the whole arm assembly should turn down taking tension off the belt. You can then slide the serpentine off of the idler pulley and remove the pulley.
How do you tell if your steering box needs replaced?
It gets very hard to steer
How do you tell when an oil pump needs to be replaced in a 1992 Toyota Camry?
No oil pressure
Is there a belt tensioner on 2003 Chevy Trucks for the drive belt?
Yes. There is a spring loaded arm attached to the block (or head) to keep tension on the serpentine belt. You can tell which pulley it is because it will have a fairly long hex-shaped spindle in the middle (for putting a wrench on to better relieve the tension). Look for a pulley with nothing much behind it.
Can a GFCI breaker go bad and how can you tell if it needs to be replaced?
Yes, a GFCI breaker can go bad. You can tell if it needs to be replaced if it is not tripping when it should, if it is tripping frequently without any apparent reason, or if it is not providing proper protection against electrical shocks.
Can someone please tell you where you can go on the internet for a schematic of how to install a tension belt for a 1993 Plymouth voyager that is free?
I JUST CHANGED MY TENSION BELT. THERE IS A SHINNY PULLEY RIGHT BEHIND THE UPPER MOTOR MOUNT. TAKE A 15MM, THERE IS A BOLT ON IT, PULL CLOCKWISE, THE PULLY SHOULD RELEASE THE TENSION
Can a GFCI outlet go bad and how can you tell if it needs to be replaced?
Yes, a GFCI outlet can go bad over time due to wear and tear. You can tell if it needs to be replaced if it no longer trips when tested, if it fails to reset, or if it shows signs of physical damage or discoloration.
How can you tell when your vacuum cleaner should be replaced?
You can tell that your vacuum cleaner needs to be replaced when it quits working properly. Signs of that include the belt quits turning or the vacuum quits picking up dirt.
How do you tell when a timing belt needs to be replaced?
Look for a mileage schedule in the maintenance section of the owners manual.
How can you tell if timing belt needs replacing?
You can't and that is why they are replaced at a set mileage as outlined in your owners manual.
