I usually take the key out, turn it, and put it back in ignition to start
Obviously get more fuel for the tank. You want to turn the ignition on but without turning the car over. When you do this listen for a whirring at the back of the vehicle . Verifying pump operation. Rinse and repeat 3-5 times . Then turn the motor over and start vehicle. If the vehicle does not start , continue to prime with the ignition and try again to start
turn ignition switch to run do not start press gas pedal to floor three times within five seconds change oil light will flash if you did it rght turn off then start engine then you are done
Old fan belt. Try replacing it.
Put it in park , insert the ignition key into the ignition and turn the key to start it.
To turn off the change oil light on a 2000 Oldsmobile Intrigue, first, ensure that the oil change has been performed. Then, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Finally, turn the ignition off and then back on to check if the light has reset.
ensure there is diesel in the car. Turn on ignition but don't start the engine yet. Watch dashboard and look for a small light (not ignition light) look for a heater plug light. When this goes off then turn ignition full turn and engine should start.
Probably the ignition key switch...I have the same problem
To reset the change oil light in a 2000 Oldsmobile Intrigue, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Then, turn the ignition off and back to the "ON" position to check if the light has reset. If the light is off, the reset is successful.
Well you put the key in the ignition and you turn it.
Replace the tumbler assembly, it is broken.
The ignition cylinder is the part you turn your key in to start the car, this is in its housing.
Not on a push mower that has no electric start. On a riding mower, yes there is an ignition key.