On most vehicles, just retract the clip & pull straight up.
# Remove the windshield wiper arms # Remove the cowl cover # Disconnect the electrical connector from the wiper motor # Detach the wiper motor/linkage assembly from the cowl # Remove the wiper motor retaining bolts and remove the motor
To remove the wiper arm on a 1993 Grand Am, first lift the wiper arm away from the windshield until it’s at a 90-degree angle. Locate the small retaining nut at the base of the wiper arm and use a socket wrench to remove it. Once the nut is removed, gently wiggle the wiper arm to loosen it from the splined shaft and pull it off. Be careful not to damage the windshield while doing this.
The 1993 Pontiac Transport windshield wiper control module is located on the firewall in the engine compartment. The windshield wiper control module will be on the passenger side of the firewall.
The windshield wiper relay is under the dash on the drivers side of the passenger compartment.
The 1993 Mercury Villager takes 22" replacement windshield wiper blades on both sides front.
They are both located under the plastic wiper cowl in the area between the hood and windshield. Remove the wipers (if you aren't sure how to do that you pull the tabs about 3/4 of the way out) then you remove the screws in the wiper cowl. Once it is removed you should see both the wiper motor and control bar.
To remove the wiper arm on a 1993 Dodge Dynasty, first, lift the wiper arm away from the windshield to access the base. Use a small socket or wrench to remove the nut securing the wiper arm to the pivot shaft. Once the nut is removed, gently wiggle the wiper arm back and forth while pulling it upwards to detach it from the shaft. Be cautious not to damage the windshield during this process.
To remove the wiper arm assembly from a 1993 Mercedes 190E, first, lift the wiper arms away from the windshield. Then, locate and remove the nut securing each wiper arm to the pivot post using a socket wrench. Once the nuts are removed, gently wiggle the wiper arms to loosen them from the post. Finally, pull the wiper arms straight off the pivot posts to complete the removal.
First, remove the windshield wipers. Then you can remove the cowel just in front of the windshield. There are a bunch of screws connecting it to the firewall. Once you remove this, close the hood. Now everything is easily accessible and the rest is intuitive. Replace everything by using the opposite procedure.
This needs more details.
The 1993 Geo windshield wiper fuse can be found in the fuse box. The exact location of the windshield wiper fuse will be listed on the inside cover of the fuse box.
top of the fire wall under the hood your wiper arms will connect