To remove the wiper arm on a 1993 Grand Am, first lift the wiper arm away from the windshield until it’s at a 90-degree angle. Locate the small retaining nut at the base of the wiper arm and use a socket wrench to remove it. Once the nut is removed, gently wiggle the wiper arm to loosen it from the splined shaft and pull it off. Be careful not to damage the windshield while doing this.
look at the half circle clip on the side of wiper arm. lift the wiper arm and pull the clip out as far as it goes the wiper arm should rest on the clip and now be "locked" up in the air . now you should be able to remove the wiper arm
Find the largest hammer you can, strike the wiper repeatedly, remove, duct tape new wiper on.
To remove the wiper arm assembly from a 1993 Mercedes 190E, first, lift the wiper arms away from the windshield. Then, locate and remove the nut securing each wiper arm to the pivot post using a socket wrench. Once the nuts are removed, gently wiggle the wiper arms to loosen them from the post. Finally, pull the wiper arms straight off the pivot posts to complete the removal.
First make sure the wipers are parked. Next open the hood of the car. You have to pull the wiper out and there is a small tab on the arm that you pull out that will release the wiper arm.
To remove the wiper arm on a 1993 Dodge Dynasty, first, lift the wiper arm away from the windshield to access the base. Use a small socket or wrench to remove the nut securing the wiper arm to the pivot shaft. Once the nut is removed, gently wiggle the wiper arm back and forth while pulling it upwards to detach it from the shaft. Be cautious not to damage the windshield during this process.
To remove the wiper arm on a 1997 Mercury Grand Marquis, pull outward on the small tab located near the end of the wiper arm. This unlocks the arm. Take a flat-head screwdriver and insert between the wiper end and the base. Gently twist back and forth until the wiper arm begins to lift off the cog. When it is loosened enough, lift straight off. To install a new arm, complete the steps in reverse. Push the tab in to lock in place.
Many wiper blades on a 1998 Grand Voyager are held in by a clip. Push the clip towards the arm, and then push the blade back. When the wiper blade is free from the hook, disconnect it from the arm by pushing the wiper down the arm a few inches. It will be free and easy to remove. Now remove the old wiper, and prepare the new wiper. Aim the hook towards the new wiper, it will go over the top. Push the blade towards the end of the arm, until it clicks. Once it clicks, it is in the correct position.
I just replaced the wiper transmission on a 2003 Sunfire. I assume the wiper system is the same as your 2002 Grand Prix. To replace the wiper arm you have to remove the plastic cap that covers the nut that holds the arm onto the stud. Once you have the cap removed and can see the nut, just unscrew it from the wiper arm. When the nut has been removed pull the wiper straight up from the stud. It might be a little difficult to remove. There is a spring underneath the top potrion of the wiper arm. Pull the front of the arm up and pull the bottom part of the arm straight up and it should pop off. Hope this is helpful to you. Good Luck!
To remove the wiper arms on a 2005 Dodge Grand Caravan, start by lifting the wiper arms away from the windshield. Locate the small retaining nut at the base of each wiper arm and use a socket wrench to remove it. Once the nut is removed, gently wiggle the wiper arm to loosen it from the splined shaft, then pull it straight off. Be careful not to damage the windshield or the wiper motor during the process.
Remove plastic cap. Remove nut. Pry up wiper arm.....
Remove the wiper arm retaining clip. The retaining clip will be just below the wiper arm connection. Hold the retaining clip in and the wiper arm will come off.
A wiper arm on a 2001 Honda Civic is screwed on. To remove it unscrew the mounting hardware and take off the wiper arm.