answersLogoWhite

0

To adjust the accelerator pump on a Weber carburetor, first locate the adjustment screw on the pump mechanism. Turn the screw clockwise to increase the pump's output or counterclockwise to decrease it. After making adjustments, ensure the throttle is fully closed and check for a proper squirt of fuel when the throttle is opened quickly. Fine-tune as necessary to achieve optimal performance without flooding the engine.

User Avatar

AnswerBot

5d ago

What else can I help you with?

Related Questions

What is an accelerator pump in my 1976 GMC half ton?

Im guessing you have a carb, the accelerator pump is in it.


What size carb trx 300?

32mm keihin with accelerator pump


Where is accelerator pump on a 1978 ford f100?

Pump is on front of Carb. square panel with four screws.


Why does your suburban want to die when accelerating?

On my engine,the accelerator pump on the Carb is going bad, 350 engine with quadrajet carb


Accelerator pump adjustment on demon carb?

About 1/64" from bottoming out when throttle is wide open.


Why would your car sputtered to a stop as you try to accelorate from a complete stop?

first of all is it injectors or carb, if a carb it could be a bad accelerator pump


Why does a 66 corvair backfire through the carb?

The timing is set incorrectly. Carburetor(s) needs rebuilding (bad accelerator pump). Firing order is mixed up. Replace or adjust ignition points and condenser.


What will cause a Chevy 350 V8 engine to cut off when the accelerator is pressed?

if it runs fine until you push the gas pedal the accelerator pump may be bad if it has a carb on it.


Is double pumper same as a 4 barrel carb?

a double pumper is a 4 barrel carb. commonly made by holley. they were called this because they have two accelerator pumps. one on each float bowl on either end of the carb. most carbs do not have this feature, they usually only have one accelerator pump.


Why does your 1963 Plymouth valiant hesitate at launch?

Could be, Accelerator pump in carburetor is not working, (rebuild carb) Timing is off, (adjust timing) Vacuum advance not working, (replace vacuum advance unit) Points are in need of replacing or adjusting,


What causes a 69 Chevy 350 to start but die when you rev the engine during the first start?

carb problem my guess would be accelerator pump or stuck power valves in carb.


Why does your 1983 Chevy Camaro bog down?

make sure the timing is right, no vacuum leaks, or the carb could have a bad accelerator pump in it.