answersLogoWhite

0

You will need help to bleed the brakes on a Honda Civic. One person needs to pump the brake pedal several times then hold it down. The other then needs to open a wheel bleeder valve, and let the air/fluid mix come out until the pedal reaches the floor. Close the valve and repeat until no air comes out with the fluid. Then move to another wheel.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How to put brake pads on a 1994 honda civic?

To put brakes pads on a 1994 Honda Civic, you will need Bleed brake fluid.


How to change the brake fluid on a 2004 Honda civic?

Remove as much fluid from the Civic brake fluid reservoir as possible, using a syringe, turkey baster, etc.. Open the wheel bleeder valves and let the lines drain. Refill the system with new fluid and bleed the lines to finish the fluid change.


What kind of clutch fluid for a 1998 Honda civic?

DOT 3 brake fluid


What kind of brake fluid do you use for your 97 Honda Civic clutch?

Brake Fluid Dot 3 Note: Brake and Clutch fluid are the same


What kind of brake fluid do you use in a 1999 Honda Civic?

DOT3


What do you do when your brake light comes on on your 1997 Honda Civic ex?

Check your brake fluid level!


When do you change the brake fluid on a Honda Civic 2007?

Per Honda Civic manual, at every 3 years independent of mileage !


Do ou have to bleed the brakes on a 1992 Honda Accord that is abs?

If you replace any brake component that breaks the brake fluid seal or you let it get very low of brake fluid, yes, you must bleed the brakes.


What kind of brake fluid do you use in a 1995 Honda Civic?

DOT 3 OR 4


How do you bleed the brakes on a 1995 Honda civic?

Start pumping it first then go about bleeding the break fluid


What type of brake fluid you should use for 1994 Honda Civic?

I recommend you use only genuine Honda Brake Fluid DOT3 but you can use another brand as long as it is DOT3.


What type brake fluid use for 1993 Honda civic?

Brake fluid type is Dot 3. It should also say on the reservoir cap.