answersLogoWhite

0

According to the Subaru service procedures, there is no bleeding necessary for the Legacy. Filling procedure is as follows. 1) Fill engine coolant into radiator up to filler neck position. Coolant capacity (fill up to

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do you bleed the cooling system 1995 Nissan questafter the thermost has been replaced?

There is no reason to ever bleed a cooling system.


When do you bleed a radiator 1996 Monte Carlo ls?

Any time you flush out the cooling system you need to bleed the cooling system.


1988 Acura Legend bleed cooling system?

How do you bleed the cooling system of a 1988 acura legend? Is there a bleeding screw and where is it located?


How do you bleed air out of cooling system Chevy Blazer 4.3?

If the cooling system is in good working order the system will bleed the air out itself. If the system has a leak anywhere no matter how small the system will never bleed the air out.


How do you bleed air from a 2006 Chevy impala 3.5 cooling system?

there should be a air valve on the engine that you can bleed the bubbles out of the cooling system.


Where is air bleed valve on radiator for subaru legacy?

no air bleed valve. all you need to do is to remove the radiator cap and let the car idle for a few minutes.


Do you have to bleed the cooling system after changing a radiator hose?

NO!!!!!


How do you bleed the air from the Engine cooling system on Chevy truck?

Engine cooling system is not a closed system you can't remove the air.


Where is the bleed valve for the cooling system on 5.7 liter gm suburban?

The cooling system bleed valve, on your General Motors 5.7 liter engine, is located on the bottom of the radiator. The bleed valve should be in the middle of the radiator bottom.


Bleed air from clio cooling system?

There are various ways to bleed air from Clio cooling system. The best option is to run the system for a while with the cap up while making increased revs. Ê


How do you bleed air from the cooling system of a Chrysler Concorde?

The bleed screw is by the thermostat housing it looks like a brake bleed screw


How do you bleed the cooling system on a 1995 Lincoln?

you dont bleed cooling systems you have to take it to a mech. shop or have the proper equipment and the r-134a on hand to do it your self.

Trending Questions
Emission light stays on and occasionally goes off but comes back on again how can this be rectified? Why does the dynamic stability control and yellow brake warning lights stay on continuously on a 2002 BMW Z3 Roadster? Why is a newly installed car battery hissing? Where are the wires for a front speaker of a stereo system located and how can you access them? What are 3 search engines available to search for information? How much is it to fix your transmission? How do you adjust the clutch on 1991 Chevrolet 2500? What car uses Albany brake pads MKD 632? Is timing belt on Kia 2004 optima covered under the power train warranty? Nissan sentra 1994 GXE 1.6 Liter brand new alternator and battery still gives you the battery light on What is the problem with your POS battery keeps getting drained so what should i do? How do you replace the headlight bulb located on a 2000 GMC Safari? What if your clutch pedal isn't working until you pushe it more than halfway in and its hard to downshift 1989 Honda prelude 2.0? Can you charge a 24 volt system with a 12 volt charger? How to Replace 5.9 dodge diesel oil pressure switch? What are the torque specs for a 2002 ford escape 3.0 liter engine intake manifold? What type of transmission fluid to use in a 2009 kenworth? How 1995chevy k1500 stalls runs rough code 44 lean condition replaced fuel filter rotor and cap plugs and wires and o2 sensor with no help could it be ecm or maybe clogged catalitic converter? What causes car to make scrubbing sound at certain speed? What transmission is in a 4 door 1995 Chevy Tahoe 4x4? Do i Need to change air filter?