How do you bypass the factory amp and still use the factory speakers?

How do you get a aftermarket radio to work if you have the factory amp?

bypass the factory amp

How do you bypass a Bose amp in a 1991 Chevy Caprice classic?

You have to use it if you still have the factory radio and speakers. With an aftermarket radio and speakers, you can wire in a bypass module available at Best Buy or most places that sell car audio. Or, insted of buying the module, you can also run new speaker wire from the radio to the speakers.

How do you bypass factory amp in 2001 Tahoe and where is the amp located?

Thanks

Can you bypass the factory amp in a Jeep Cherokee?

Yes, you can bypass the factory amplifier in a Jeep Cherokee by using a bypass harness or by directly connecting the head unit's output wires to the speakers. This involves disconnecting the factory amp and routing the audio signals from the new head unit directly to the speakers. However, it's important to ensure the wiring is done correctly to avoid damaging the audio system. Always consult the vehicle's wiring diagram or seek professional installation if unsure.

How do you bypass the factory amp what are the color codes?

It's best to install new speakers and your own amplifier. The stock system in these cars might say JBL but it's junk and you will see this when you remove one of the speakers. If you want to use existing speakers and amp no need to bypass amp. All that is needed is 12 volt switched power source to the amp through the harness(blue wire). Just completed on my 91 mercury grand marquis.

How do you bypass the amp in a 2002 Jeep Liberty?

Well, you do not necessarily have to bypass the amp. If you are using aftermarket speakers, you will have to bypass it, because the speaker will be receiving power from the head-unit AND the factory amp (speakers cannot have 2 power sources). This can be done with a bypass harness from www.crutchfield.com or you can just run your own speaker wires from your head-unit to your speakers. But, you will need aftermarket speakers, because the stock speakers are not designed to just be powered by your aftermarket head-unit, they're designed to be powered by the factory amp. However, if you are using the stock speakers, and just wish to use an aftermarket head-unit (what I did on my 06 liberty w/ "premium infinity sound"), all you have to do is power the factory amp (for each speaker). With a factory amp, your factory head unit sends power to the factory amp, when the car is turned on. Your aftermarket head-unit/harness, is not designed to power a factory amp. For this reason, your factory amp has no power, so you get no sound from your factory speakers. The Fix: Create a power source for your factory amp. People commonly use the "power antenna" wire (used to make an antenna go up/down when the car is started/stopped). This is simply a wire that has voltage when the car is on, and is dead when the car is off. The power antenna wire is located in the back of most aftermarket head-units. Just wire the power antenna wire (the one from the back of your aftermarket head-unit) to the factory amp power wire (this wire was originally attached to the back of the factory head-unit), and it should get power. You should now hear sound from your speakers. Each vehicle has different colored wires, so make sure you look at a 2002 Jeep Liberty wiring diagram for the color of your jeep's factory amp power wire. This can be found online. I know that was a bit lengthy to read, but I wanted to be sure that you would understand! Hope that helps! -alex

How do I bypass the factory amp in 1990 Grand Marquis?

you dont

Bypass factory amp 96 Cadillac deville?

Find the amp located behind the back seat. Disconnect the power. Run all new speaker wires from your speakers to the back of the new radio, if that's what you're installing. If you don't do this, you're battery will drain because the car will think the factory radio is still on. and only your tweeters will work

Is there a factory amp in a 2004 dodge ram and where is it?

There is an amp only if equiped with factory infinity stereo with 7 speakers. If so, the amp is behind the glovebox.

How do you bypass the amp for your stereo system and still get all of the speakers to work?

dude it is an electrical nightmare for some. but if you go to best buy or call crutchfield or possibly your dealer they do have a bypass unit you can plug into it.

How do you bypass a factory amp in a 1993 Honda Prelude?

Best luck I have had is to re-wire the speakers...... It may take some time but, it works. And you can use higher quality speaker wire...

How to install an amp to a factory radio of a 2012 dodge ram 1500?

To install an amp to a factory radio of a 2012 Dodge Ram 1500, ensure that the amp bypass the harnesses.