answersLogoWhite

0

If it's a serpentine belt, all you have to do is put a socket on the tensioner pulley, rotate it counterclockwise, and that should give you the slack you need to remove the belt. You do the same thing installing the new belt, and refer to the belt diagram when routing the belt.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you change serpentine belt on a 99 olds cutlass?

You have to unscrew the motor mount srews.


How do you change serpentine belt 1997 ford pickup4.6 motor?

pull the tencion pully all the way back and then place it on.


What belts are on a 2002 Chevy Malibu?

Just a serpentine belt. May have to remove a motor mount in order to change it, that varies by the year.


Where can you find a Caterpillar diesel motor serpentine belt diagram?

A Caterpillar diesel motor serpentine belt diagram can be obtained from most Caterpillar dealerships. The serpentine belt diagram can also be found at many truck parts stores.


Where is the Jeep Grand Cherokee serpentine?

The serpentine belt goes around all of your pullies in the front of your motor, behind the radiator.


How do you change the serpentine idler pulley serpentine tensioner and serpentine belt on a 1999 Nissan ALtima?

remove belts idler is to close to fire wall to come off after you remove nut.jack up car and put stands under.how put a jack under engine . remove top motor mount bolt and jack engine up this will give you the room to change idler pully.


Where is the serpentine belt on a 2002 Chevy Trailblazer?

Right on the very front of the motor.


How do you change the Serpentine Belt for 2005 Nissan Sentra?

Depends on the motor... but on the 1.8-liter, there are two loosening/tightening screws. One for each belt. Very easy removal and installation.


How do you change a Serpentine belt on a 2003 Oldsmobile aurora?

Floor jack under motor for suppor. Remove windshield fluid reservoir, passerger side motor mounts, plastic fasteners and shield inside right wheel well. You cant pull the motor mount out but you can snake the belt around it.


What is the tensioner on 2002 Chevy Trailblazer?

The tensioner/tensioner pulley is located on the passenger side of the motor and hold the tension on the serpentine belt. In order to change the serpentine belt you must relax the tension with a breaker bar or equivalent. We have more info, including diagrams at our enthusiast forum, at www.trailvoy.com


Routing for serpentine belt on 1997 grand prix with the 3800?

There is a picture in the motor compartment.


How do you change a serpentine belt on a 1999 Oldsmobile delta 88 3.8 liter?

loosen the motor mount on the right side lift the motor a little to get the belt thru drop it back down tighten it up and thread the belt on the pulleys via diagram