0
What else can I help you with?
How do you change the tail light on a 2002 dodge 1500 VAN?
I need a answer to my question. Thanks
How do you open the tail light on a 2000 Mazda 323 to change the bulb?
How do you open the tail light onTake it to a garage you tight git
How to do you change a tail light on a 2000 Dodge Stratus?
under the carpet in the trunk
How do you replace the rear brake light bulb for a 2000 GMC Sierra 1500 or how to begin to get at it?
To change brake/tail light you need to remove the two screws in the tailgate jam, by the upper support cable of the tailgate (much easier with tailgate lowered!) and the tail light housing should pop out. The socket for the light is a quarter turn counter clockwise and the bulb is exposed.
How do you change the tail light in a 2000 Miata?
hi you unscrew the whole of the light 2/3 with x screwdriver from the outside.
How do you change the tail lights in a 1988 Chevy 1500?
Open the tail gate and look at were the straps that hold the tail gate are at on the sides of the bed. Now look at the 2 Phillips screws and remove them then the light will come out.
Rapid blinking tail light on your 2000 blazer s-10 how do you change it?
The tail light bulb is probably okay, it's the front signal light that is burned out, this would cause the rear light to blink rapid.
How do you change the rear tail light on a 2000 Ford Escort ZX2?
Hey Jesse==You have to take the tail light completely off. The bulbs go in from the back Good Luck Joe
How do you change tail light in Toyota sequoia?
How do you change the tail light on a 2001 toyota sequoia
How do you change a tail light on a 2006 sequoia?
how to change tail light bulb on Toyota sequoia
How do you replace tail lights on a grand am 2000?
from inside the trunk just take the plastic pins out that hold the carpet directly behind the tail light and twist the light socket out and change the bulb
How do you change tail light on 2000 Oldsmobile Intrigue?
Remove the rear tail light assembly by pulling the carpet back and unscrewing three thumb screws. Pull out the tail light assembly and the bulb sockets will be visible. twist out the socket to access the bulb. Install is reverse.
