This is easy, go to parts store and get a haynes or chiltons book on your truck 15 or 20 bucks I did mine in the garage. It would take too much typing to walk you thru it. If you have any mechanical skills, and can follow directions you should be in good shape. If not better pay to have it done.
You will need to remove the speaker covers in your 2006 Chevrolet Silverado. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
In the back dummy
on the back of the gas tank
Changing brakes is pretty simple. A person has to lift the car with a car jack, remove the tire, brake shoe, and old brake pad. Then put in the new brake pad, replace the brake shoe, put the tire back on the car, and lower the car.
About $400.00 each. Front and Back double.
look at it,, figure it out change the damm brake
To change the back brake on the 2000 FXD kindly refer to your user manual.
take off the 2 bolts holding the brake caliper on lift it up off the break drum remove the old brake pads . Use a c clamp to push the plunger back in incert the new pads bolt it back in place.
remve the tail light they are on the back side.
That will be the very back cylinder on the drivers side head.
Check bulbs?
If you have the towing package it is in the 7 pin blade connector next to your receiver hitch. and that runs back to underneath your dash for brake controller hookup. 2000 Chevy Silverado LT Ext Cab 4 dr 5.3L 4x4 Z71