To change the brake light on a Jeep Commander, first, open the rear hatch and locate the tail light assembly. Remove the screws or bolts securing the assembly, then gently pull it out to access the bulb sockets. Twist the socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble the tail light by reversing the steps. Always ensure the new bulb is properly seated before securing the assembly back into place.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
The brake light bulbs ar removed from the rear of the light assy . Take it off of the body.
To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.
under the brake pedal
The brake light switch is behind the brake pedal.
See sources and related links below for the 2004 Jeep Liberty Brake Light Lamp Numbers.
w to replace center brake light in 2004 jeep liberty
The brake light switch is connected to the brake pedal and the brake linkage under the dash with a single bolt.
Yes.
just behind the leg on the brake peddle
You already have a 3rd brake light behind the rear glass. Do you mean change the bulbs? If you do need to change the bulb then all you need to do is take off the paneling inside on the liftgate and you will have access to your lights.