answersLogoWhite

0

Simply remove the trim panel around it, take off the control knob and unplug it, unscrew the screws and replace it with a new one.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Where can you buy an ignition switch for a 1997 Geo Metro?

www.advanceautoparts.com


In a 1997 Jeep Wrangler Where is the relay switch for the heater blower motor?

In a 1997 Jeep Wrangler, the relay switch for the heater blower and motor is located behind the dash. It will be directly behind the HVAC knobs behind the dashboard.


Why does only the HIGH blower work on my 1997 Nissan maxima?

Your blower switch sensor is out. Replace it!Then all the speeds will work


Why your 1997 marquis not working on low after you change resistor?

Assuming you are asking about the HVAC blower motor, check the condition of the switch and the electrical connection at the switch. And, if the original resistor was burned out the cause is usually because of the blower motor drawing too much current. If so, replace the blower motor or you will burn out another resistor soon.


How do you change a fan switch on a 1997 Chevy cavalira?

how do you change a fan switch on a 1997 Chevy cavalira


How do you replace heater blower fan switch on a 1997 Toyota RAV4?

take the old switch out, put a new one in


Why does the blower switch work on all but high for 1997 GMC Safari?

You need to replace the blower motor resistor. I've been there done that.


How do you change a ac fan switch on a 1997 Chevy cavalira?

how do you change a ac fan switch on a 1997 Chevy cavalier


What is wrong with your 1997 s10 if the blower motor will not work?

If you have no blower speeds at all check the fuse, then check the blower motor switch and electrical plug for a melt down situation, then check the blower motor itself.


How do you replace the dimmer switch in a 1997 Honda Accord?

how to change dimmer switch on 1997 Honda accord


How do you remove an ignition switch from a 1997 Geo Metro?

To remove the ignition switch from a 1997 Geo Metro, start by disconnecting the battery to ensure safety. Then, remove the steering column covers by unscrewing the screws and gently prying them apart. Locate the ignition switch, typically secured by screws or bolts, and disconnect the wiring harness. Finally, unscrew the ignition switch and remove it from the steering column.


No blower motor speed 123 only max on Nissan Maxima 1997?

change the blower motor resistor. done deal.