answersLogoWhite

0

To change the ignition switch on a 1995 Mercury Tracer, first disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing the screws and gently prying it apart. Locate the ignition switch, detach the wiring harness, and remove the mounting screws to replace the switch. Finally, reassemble the column cover and reconnect the battery.

User Avatar

AnswerBot

3mo ago

What else can I help you with?

Related Questions

How do you replace ignition lock cylinder on a 1996 Mercury Tracer?

Begin by removing the retaining ring at the top of your 1996 Mercury Tracer ignition switch. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the cylinder. Reverse the process to install your new ignition lock cylinder.


How do you set the ignition timing on a 1994 mercury trio tracer?

You can't. Computer sets it. Chuck the Tracer pro.


Why does 1996 Mercury Tracer's Ignition Switch lock-up and release only when shifter is removed from park position and replaced?

The ignition switch on a 1996 Mercury Tracer might lock up and release only when the shifter is removed from park and then put in the park position again because the sensor is getting worn. This sensor lets the ignition know that the car is in park and it is safe to remove the key. Check the shift position sensor.


How to set the ignition timing on 91 Mercury Tracer?

can't. computer does it automatically.


Where is located the ignition module in a mercury tracer 1989?

ignition control module is located under the distributor cap


Does a 1999 mercury tracer have a fuel pump relay switch?

Yes


How do you remove the ignition tumbler in a 1995 mercury tracer?

3 screws facing the engine


Where is the fog light switch on a 99 mercury tracer?

Assuming it is the same as the 1998 Mercury Tracer : The fog light switch is on the turn signal lever , next to the head light switch * you probably need to have your head lights on low beam


How do you remove a 1993 mercury tracer ignition switch if you HAVE the ignition key and can turn it to the on position?

you need to push in the hole with 1/8 inch screw driver under the steering column, below your ignition switch. there is a release button in there and it just pulls out once you have that release button pushed it's actually quite easy..


Change transmission light in a Mercury Tracer 1999?

There is no change transmission lamp.


How do you replace door speaker in a 1997 murcery tracer?

How to change door speakers on a 1997 mercury tracer wagon


Where is the brake light switch on 1997 mercury tracer?

the brake light switch is just above the brake pedal. I just bought one for my own 97 tracer yesturday and need to install it.