To change the light switch on a 1993 Geo Storm, first disconnect the negative battery terminal to ensure safety. Remove the steering column cover by unscrewing the screws, then locate the light switch, which is typically attached to the turn signal assembly. Disconnect the wiring harness from the old switch, unscrew it from its mounting, and install the new switch by reversing the process. Finally, reattach the steering column cover and reconnect the battery.
The break light switch is located on the backside of the break peddle arm.
Gm vehicles do not use ineria/reset switches.
To remove the ignition switch on a 1991 Geo Storm, first, disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing the fasteners, exposing the ignition switch. Disconnect the wiring harness from the switch and remove the screws securing the ignition switch in place. Finally, gently pull the ignition switch out from the steering column.
There isn't a switch to reset the light. You 'reset' the light by fixing the problem which is causing the light.
For an automatic transmission, check the side of the transmission by or at where the shifter linkage goes into the trans. For a manual transmission, check under the shifter boot.
Inflatable Restraint... air bag.
i checked and found unplugged wires
depends on years storm and tracker are more closely related call parts house and compare part numbers
Remove the fuel tank then the gauge and pump.
Check the alternator.
The U S light in yellow/orange is an "UP SHIFT LIGHT" this is a manual transmission. this is for fuel economy
it can be done but you will have to change all of ur wirring harness from the prism because the prism is basically a Toyota and a storm is a izuzu impulse knockoff