my Sedona 2005 just tune up ...but some time loss power..same time is normal....and the sound of exhaust is not silent like normally .....and to much gasoline consumetion.....
there is no MAP sensor on a Kia Rio from 2001 to 2005 they have Mass Air Flow Meters, and to change that you will have to remove the air box sitting next to the firewall as it it bolted to that box
To change the MAP sensor on a 2004 Kia Sorento, first, disconnect the vehicle's battery to prevent any electrical issues. Locate the MAP sensor, which is typically found on or near the intake manifold; disconnect the electrical connector and remove any mounting screws. Take out the old sensor and replace it with the new one, ensuring it is securely fastened and the connector is reattached. Finally, reconnect the battery and start the engine to check for proper operation.
in line with the air filter
To replace the map sensor on a 2004 Kia Sorento, first ensure the engine is off and disconnect the negative battery terminal. Locate the MAP sensor on the intake manifold, usually near the throttle body, and disconnect the electrical connector. Remove the mounting bolt(s) and carefully pull the sensor out. Install the new sensor by reversing the steps: insert it into place, secure it with the bolt, reconnect the electrical connector, and reattach the battery terminal.
on left side of engine compartment , in front of brake master cylinder
It uses a MAP sensor.It uses a MAP sensor.
change the map sensor
The driving distance from Salt Lake City to Sedona is 538 miles per Map Quest. The driving time to Sedona per Map Quest is 9 hours.
the map sensor should be on the right fender well or right fire wall it has one wire plug and one vacume plug
It depends. If the sensor is working, just reset the computer. Otherwise you have to change the sensor.
a map sensor is a manifold absolute pressure sensor.
No vacuum change at the MAP sensor.