You didn't give us the year of the vehicle so in general... Mitsubishi Outlander center high mount stop (third 3rd brake light) light bulb lamp replacement procedure: Purchase the correct replacement center high mount stop (third 3rd brake light) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information and full light bulb part numbers list. Then consult your owner's manual for the center high mount stop (third 3rd brake light) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. If there are multiple bulbs, you may want to consider replacing all at the same time in order to keep brightness and color equal (optional).
To reset the change engine oil light in a 2003 Mitsubishi Outlander, turn the ignition key to the "On" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then start the engine; the oil light should be reset and go off. If the light remains on, repeat the process.
I had the same problem on my 2005 Outlander. Oil pressure light turned on erratically when the motor was hot and I was on idle. Mitsubishi repaired it on guarantee, the oil pressure switch was defective, they changed it. JJ
The parking brake light stay lit on the 1999 Mitsubishi Montero sport the parking brake is working and you have not put the light off.
To change the parking light on a Mitsubishi Outlander, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the headlight assembly; you may need to remove a cover or fastener. Twist the socket counterclockwise to remove it, then pull out the old bulb and replace it with a new one, ensuring it’s securely in place. Finally, reinsert the socket into the assembly and close everything up.
there are plastic covers over them on the inside of the trunk that you pop off
I have a 2003 Outlander and tail light is similar- check out the WikiAnswer for the 2003 which helped me remove my tail light assembly.
what do you have to do to change the center brake light
I just had to change mine yesterday 4/12/08 you have to open your trunk, look right under where the 3rd brake light is to find wire running to it, twist to pop it out. Hope this helps. B.C.
Warning light? Check fluid level in master cylinder Make sure parking brake is fully released 2004 mit. outlander
Look at page 3-175 of your owners manual. It tells you there.
WHICH brake light?
Open the turn there is a little hatch take it off twist the light out and pull the bulb put the new one in simple.