0
Well they should have connectors on them, if they dont then i would advise you get a mechanic to do them since you seem unfarmiliar with the process. If they do have connectors on them (they most likely do, or there would be no way to connect them) then just connect them this way: Put on the negative and screw it down, then put on the positive and do the same. Its not going to shock you if you only touch on of the connectors at a time. Also make sure, not to touch the car (like leaning on it) while you are touching the positive (red) connector or you could get shocked.
What else can I help you with?
What happens if you connect the ground wire to the terminal and the red wire to the - terminal on the car battery ie connect the battery backwards but did not start the car?
once a battery is connected even if the key is not in the ignition, there is always power at certain points in your car. Connecting a battery backwards will not start your car, but it can and will fry the wires to your starter.
Can you connect a car battery to a three wire cable?
Sure, just use 2 of the wires and ignore the 3rd one.
Where do you connect the negative battery cable wires?
At the battery if at all possible.
Which battery post do you connect first when replacing a car battery?
You connect the positive terminal first.
How do you connect copper wires to battery?
i will tell you how if you tell me what this project is called,it uses light bulb, copper wires,holder,6 volt battery.
Can loose wires cause a car battery not to start?
Certainly, a loose wire on the car battery can cause the car not to start.
How do you hook up wires to a starter solenoid combination?
To connect wires to a starter solenoid combination, first ensure the vehicle is off and the battery is disconnected for safety. Attach the battery positive cable to the terminal labeled "B" or "Battery." Next, connect the starter motor wire to the terminal marked "S" or "Starter." Finally, if applicable, connect any additional wires, such as ignition or relay wires, according to your vehicle's wiring diagram, and then reconnect the battery.
How do you wire up a car horn and button?
To wire up a car horn with a button you first need to run one of the wires from the horn to the battery. Take 1of the wires from the horn and run it to where you want the button to go. Connect the wire to the button and that's it.
How should you connect the battery to the car?
Connect the negative cable first.
Is it an open or closed circuit when the wires dont connect from the bulb to the battery?
open
What two wires connect to the timer switch on a century 87423 battery charger?
The two wires which connect the timer switch on a Century 87423 battery charger are the red and black wires. The red goes to the positive connector while the black goes to the negative connector.
How do you hook up and charge hydraulic batteries with the car alternator?
start your own car like it was a regular old day. while the car is still on disconnect the car battery and remove it, get a pair of jumper cables connect them each end to the battery wires (positive to positive and negative to negative). get your hydraulic battery you gotta put it on something other then the ground. connect the other end of the jumper cables to the battery and charge its that easy. if you don't get how i just explained it sorry.
