== ==
Connect the positive cable to the positive battery post on the donor car and on the Corvette. Connect the negative cable to some metal part of each vehicle, such as the engine. Be careful of the fan blades on each car. Let the donor car run for approximately 15 minutes to put a slight charge in the battery on the Corvette before you attempt to start it. Start the Corvette and as soon as it starts disconnect the battery cables.
To get a 1990 Corvette to start if it turns over and the battery is good, check to ensure the fuel filter is not clogged. You also need to ensure it has plenty of gasoline.
check the battery and connections/cables
You can't. You must access the battery to jump start the car. Why can't you get to the battery? Unlock the door with your key, and open the hood.
Yes.
1987 chev corvette put in new altornator and battery.started that day ,the next day it wood not start ,gave her a jump and it wood start ,but then i wood take the cabbles of the battery and it would die agien
Start by removing the ground cable first(negative). Then remove the positive cable. At the base of the battery is a hold down clamp, held in by one bolt. Remove this and the battery will lift right out.
check netural safety switch. make sure u have a good clean ground to the battery. check ground at the frame.
A lot of the time Chevy used aluminum battery cables in their cars,(in particular my 1980) I was continually having starting and battery problems until I replaced the cables with copper.
It is the VAT system, thinking your are a car thief. Repair or replace the system.
A faulty belt tensioner and/or a worn belt. A run down battery could add to it.
alternator is bad........ my best guess.... or your battery is surface charging and cant take a load....... go to an autoparts store like advance or autozone n have them check the charging system and battery. -Jarrid-