0
To line up a pump shaft, start by ensuring that both the pump and motor are securely mounted on a stable base. Use a dial indicator or laser alignment tool to measure the alignment between the pump shaft and the motor shaft at both the vertical and horizontal planes. Adjust the position of the motor by shimming or moving it until the shafts are properly aligned within the manufacturer's specified tolerances. Finally, recheck the alignment after securing all bolts to ensure that no movement has occurred during the tightening process.
What else can I help you with?
How do you move or reset the oil pump shaft to reset the distributor and rotor line on a 73 F250 460?
I cut and welded the correct size allen wrench to an old long screw driver shaft and used that to turn the pump. You can chuck it up into a drill to prime the pump also.
What drives the water pump on a 1983 750 shadow?
The water pump is driven by the oil pump shaft - there is a tab on the end of the oil pump shaft and there is a groove on the water pump which sits into that shaft. All shafts end up being driven by the motor.
Where is the most common place for the power steering pump on a 2001 Pontiac sunfire to leak at?
The most common power steering pump leaks are at the line connections or behind the pulley at the shaft. The line leaks can possibly be repaired, but the shaft seal leak could be better to change the pump.
Can you miss the fuel pump rod on a 350 Chevy?
yes you can. of you tightened it up off the shaft pump damage probably occured or the shaft has bent.
What is shaft alignment of a pump?
The alignment of a pump is the process of making sure the pump shaft and prime mover (electric motor, engine,ect.)shaft are lined up perfect both horazonally and verticaly to ensure there is no binding on the coupling.
What causes the oil pump not to pick up?
Shaft from distributor could be stripped or the screen on oil pump my be clogged but most likely its the shaft coming from pump to the distributor is stripped or broke
Is the oil pump shaft lined up with the distributor shaft a certain way or can it be moved to get distributor gear to line up?
you can turn it with a long handled screw driver if you wish, but its easier to just turn the distributor until it drops down into place. then set your timing
On a 2003 Nissan altima what are the timing marks for the cam shaft and crank shaft and where do they line up?
there are paint marks on the chain. once you line it up it should be on tdc
What is the best material for submersible pump shaft?
Yeah, the best material simply pump shaft. I guess that pumping shaft's just the way it is
Can the water pump make the tensioner belt fall off?
If the water pump locks up, the impeller shaft is bent, or the water pump pulley is loose yes.
Does a 1994 Chevy 350 have a long or short shaft water pump?
That would be a long shaft water pump.
How do you time engine up to install injection pump john deere 2010?
the pump has a small window on the side held on with 2 screws turn pump shaft or if installed on engine turn engine over until small scribed lines line up then see that engine flywheel marks allign tdc marked grommet or plug in rhs of bellhousing
