Drivers door open
Ignition off
Switch ignition On then Off
Close then Open drivers door twice
Switch ignition On then Off
Close then Open drivers door twice
Close doors and lock using manual knob
Switch ignition On then Off Twice
Unlock using manual knob
Passenger door lock and unlock
I waited a few seconds for everything to settle, then everything worked.
If the battery has been out of the key fob for too long the fob loses its program and the car will not start. Peugeot will try to charge £48 for a reprogram but you can get around this by: - 1) Turn on the ignition 2) Hold down the close button for a few seconds 3) Turn off the ignition and remove the key 4) Start the car The above can be found on page 19 or 20 of the 407 user manual
Answerbatteries to peugeot cars have to be changed by the dealer as the key then has to be reprogrammed to each individual car. it is a pain in the backside as i used to work for peugeot. I took my key to the local car parts shop,he not only sold them but fitted them to.It was that easy.
the dealer has to program the key, they will need the car and original key.
Refers to the battery in the car key! So it means you will need a new battery in the electronic key.
To get the key code for your Peugeot, you typically need to refer to the vehicle's documentation or contact a Peugeot dealership. The key code is often found in the car's manual or provided on the key fob itself. If you don't have access to this information, the dealership can assist you by verifying ownership and providing the code. Always ensure you have the necessary identification and documents when seeking assistance.
Yes, you can. Actually you don`t program the key. Key remains unchanged, you just program the car to accept this particular key.
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.
The dealer scan tool is required to program a key on this Mitsubishi built car.
This will entail adding in some sensors to the vehicle. You can get a special remote starter and then follow the directions to set it up.
If you are having an issue with the immobilizer on a Peugeot 307 HDI, you need to recode your key. To do this put the key into the ignition and turn to the on position, hold the Lock button on the key for 10 seconds, take the key out of the ignition, and then test to see if the car starts after another 10 seconds.
you have to take it to a dealer.cost about 150.00 they have to program key to the car.
It means your car gets low signal of the remote control ( key ), you have to change your key's batteries and the problem will be solved :)