GO TO THE HARDWARE STORE AND BUY, OR LOCATE AROUND THE HOUSE 4)1-1/2" PENNY-#1 NAILS( THAT'S KUNTRY CHEEP, Y'ALL!).YOU COULD ALSO BUY THE ACTUAL "Ford RADIO REMOVAL TOOL(S)" AT ANY AUTO PARTS PLACE. DISCONNECT THE BLOWER DAMPER CONTROL CABLE( UNDER DRIVER'S DASH,RIGHT OF GAS PEDAL, APPROX. 2"-3" AROUND, BLACK, PLASTIC W/ PLASTIC CABLE POKING OUT THE SIDE- TURN COUNTER-CLOCKWISE.) JAM WHICHEVER TOOL YOU USE INTO THE FOUR HOLES( TWO ON LEFT-TWO ON RIGHT) IN THE BLACK PLASTIC DASH PANEL THAT ALSO HOUSES THE A/C-HEATER CONTROLS. PULL ON EDGES OF RADIO-A/C PANEL EVENLY. BE AWARE THAT NO "SLACK" IS OFFERED AS FACTORY OPTIONS, SO BE CAREFULL NOT TO DAMAGE WIRING HARNESS.
just give them a rely good pull ...after u have unbolted them
Did you disconnect the antenna lead?
How much weight can i pull behind my ford ranger 2000 xlt
You must buy a Ford Factory Stereo Removal Tool. then pull the radio forward and unplug the wiring in the back.
It is located in the dash left of the radio, pull the radio facing off the main radio out and directly to the left.
2000 lbs to pull.
* pull the ashtray out * undo the fixings behind the ashtray * pull the panel above the radio (carefully) * undo the fixings you see above the radio * pull radio and heating controls out * unplug * wonder what you find to fill the big hole left
It pull's off and snaps back on.
You have 4 clips that goes in the radio you put them in then you pull thats it its the best and easiest way to do it
There are 2 vertical slots at the bottom of the radio _l____l_ just push in and handles will pop out, then simply pull the radio out.
You press down on the plate inside and pull.
you will see two holes in each side of the radio, insert standard radio pins in here and the radio will pull out