Push on the bottom of the bench seat to release the clips (have to push hard) Lift bench out You will see either clips or bolts holding the rear of the seat Release these and lift rear of seat up to release upper clips to remove seat back
To remove the rear seat from a 2002 Chevrolet Cavalier, first, locate the rear seat bottom's release levers, typically found at the front edge of the seat. Pull the levers to release the seat bottom and then lift it out. For the rear seat back, look for bolts or clips at the base of the seat, remove them, and then tilt the seat back forward to release it from the vehicle. Always refer to the owner's manual for specific instructions and safety precautions.
Push lower end of rear seat back to unlock clips (takes a bit of effort) Lift bench out Should be clips or bolts holding the top of the rear seat - release these Push up on the upper section of seat to release top clips Push lower end of rear seat back to unlock clips (takes a bit of effort) Lift bench out Should be clips or bolts holding the top of the rear seat - release these Push up on the upper section of seat to release top clips
Push (hard) on the front bottom of the seat to release locking clips Lift out bench Bottom of back of seat clips or bolts will now be exposed release these clips or bolts - push up on the back of seat to release upper clips to remove seat back
A rear seat in a VW car that is stuck up can often be fixed by moving the release while gently rocking the seat back and forth. This will allow the release to disengage and move the seat.
first pull the seat forward then release the back by the leverl on the siides of the back by the seat belt lap harness
Reach under the corners of the rear seat at either end, there are clips under the seat cushion on either side of the seat. Press these up and they will click and release the back seat cushion. If the release buttons are hard to find, jerk up the rear seat a little and the release buttons are easier to feel for. The cushion can then be lifted out.
To remove the rear seat back on a 1964 Impala, first, locate the release mechanisms, which are typically found at the bottom of the seat back. Pull the release levers or push the pins to unlock the seat back. Then, tilt the seat back forward and lift it out of the brackets that hold it in place. Make sure to check for any additional fasteners or clips that may need to be removed before fully detaching the seat back.
It is behind the rear seat back.It is behind the rear seat back.
It is behind the rear seat back.It is behind the rear seat back.
It is behind the rear seat back.It is behind the rear seat back.
Push rearward on the bottom of the front of bench (takes a lot of pressure) to release locking clips Lift out bench seat You will then see bolts or clips holding the back of the seat Remove or release these Lift upward on the back of the seat to release upper locking clips Remove back of seat