answersLogoWhite

0

1)Purchase new bumper cover wing (wrap around) mounting rails and hardware 2) Open trunk and remove liner left and right to gain access to mounting hardware 3) Remove taillight harness left and right 4) Remove taillights (left and right) These are sealed and will require very careful prying away from body. Work slowly and allow the adhesive to release. 5)Completely remove the bumper cover push locks (2) beneath each taillight 6) Examine inner fender (inside trunk) for (2) bumper cover wing mounting bolts on left and right sides. Loosen but do not remove (inner bolt on passenger side is behind the jack assembly). Apply penetrating oil as necessary to loosen. NOTE: these bolts are often rusted badly and WILL break. Hence the need to purchase new mounting rails before starting work. 7) Carefully pry rear side marker assemblies from vehicle and remove wiring harness. Pry carefully from the rear. 8) Remove (2) mounting bolts beneath left and right bumper cover wings (fender) may be rusted and require vise grips and some force to pull out. 9) Remove (1) mounting behind each rear wheel (upper end of bumper cover wing) 10) Remove bumper cover corner bolts below and toward the outside corner of left and right taillight 11) Carefully remove the bumper cover wing bolts previously loosened inside the fender. Don't worry if they break, you have new hardware. 12) Carefully pull bumper cover toward the rear to free it from the vehicle. 13) Installation is the reverse of this procedure.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you remove the front bumper from a 2002 Hyundai Santa Fe?

Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.


How do you remove front bumper on 2002 impala?

how to remove front bumper 2002 Impala


How do you change a trunk light in Nissan Maxima 2002?

To change the trunk light in a 2002 Nissan Maxima, a person will need to unscrew the cover over the light. Then they can remove the old bulb and replace with a new one. Then screw the lens cover back on.


How do you remove rear bumper on a 2002 Elantra?

1. If needed raise vehicle and support it on Jack stands 2. Remove the retaining screws in the wheel wells and along the upper and lower edges of the bumper cover. Remove the tail light housings. Remove the rear trim plate and pull luggage compartment trim out for access then remove the remaining bumper cover retaining screws. Remove the bumper bolts 3. On station wagons remove the rear window washer fluid reservoir for access to the bumper retaining bolts. The remaining bumper bolts are accessible from below 4. Pull the bumper and cover assembly out and away from the car


How do you remove the rear bumper cover from a 2002 ford explorer sport?

To remove the rear bumper cover from a 2002 Ford Explorer Sport, start by removing the screws and bolts located under the bumper, typically found near the wheel wells and along the bottom edge. Next, detach any clips or fasteners holding the bumper cover in place. Carefully pull the bumper cover away from the vehicle, ensuring to disconnect any electrical connectors for lights if applicable. It may be helpful to have a second person assist with the removal to avoid damaging the cover or the vehicle.


How do you take off front bumper cover on a Saturn SC2 2002?

To remove the front bumper cover on a 2002 Saturn SC2, first, ensure the vehicle is parked safely and the ignition is off. Begin by removing the screws and clips located at the top and bottom of the bumper cover, typically found around the wheel wells and under the front fascia. Gently pull the bumper cover away from the vehicle, being cautious of any wiring connections for fog lights or other features. Finally, disconnect any electrical connectors before fully removing the cover.


How do you remove rear bumper on 2002 montero sport?

I just did this last night on mine. There is a plastic cover on the top of the bumper. You have to remove that to get to the bolts underneath it. Its a real pain to remove it without breaking that plastic cover you have to crawl underneath it and squeeze the plastic clips together one at a time. After you remove that, you can remove the bolts under it. There are more in other places, but I forget where, I'd have to go look again.


How do you remove rear bumper cover on Kia Optima?

2001-2002 I know the screws are behind the trunk panel. Two on each side I think and the ones in the back.


Can you use a 1999 infiniti g20 rear bumper cover on a 2000 infiniti g20?

Yes. The rear bumper cover was the same on the Infiniti G20 from 1999-2002.


How do you change a the small headlight bulb on an Audi TT Quattro 2002?

YOU NEED T TAKE OUT TRIM ON TOP OF RADIATOR AND HAVE LONG FINGERS TO REMOVE OR U CAMN TAKE BUMPER COVER OF AND REMOVE HEADLIGHT TO GET IT


How do you replace bumper cover on 2002 Honda?

See below- Pretty much the same thing for all 2002-2008 Civics.


Does a 2004 s2000 front bumper fit a 2002?

Yes with some slight modifications. You will have to trim the bumper support and remove the foam padding. You will also have to switch the fender liners bc the 2002 liners wont reach the 2004 bumper.