0
You will either need to buy or rent a special tool from the autoparts store. Its a thin flat wrench with another wrech looking tool that attaches to the end of a wrachet. Just ask for the tool for removing the fan clutch on a Ford Explorer. Also remember that the clutch is reverse threaded. There is also a wealth of knowledge at the following website(www.explorer4x4.com). Pick up a haynes manual as well. Hears how i did it. I removed one bolt so the cresant would fit. I used a nuckel nail puller put the short end behind the pulley and pried, put a 12in. cresant on bolt and hit the cresant with a 2lb.hammer.And it is not reverse threaded. drmack1@sbcglobal.net
What else can I help you with?
How do you replace a fan clutch on a 2003 Ford Explorer?
How to remove fan clutch on 2003 ford explorer
How do you remove clutch fan from 1993 explorer?
to remove a clutch fan on a ford, you need special tools . also fan thread is left hand thread ,so you unscrew it clockwise
How do you remove a fan blade from a 1998 Ford Explorer?
how do you remove a fan blade from a 1998 ford explorer
How do you remove the fan clutch on a 2001 Ford Ranger?
you have to have fan clutch wrenches
How do you remove a cooling fan from a 2002 ford explorer?
To remove the cooling fan from a 2002 Ford Explorer, first disconnect the negative battery cable to ensure safety. Then, remove the fan shroud by unbolting it from the radiator support and disengaging any clips or fasteners. Next, disconnect the electrical connector from the fan motor, and finally, remove the bolts securing the fan to the water pump or clutch assembly. Carefully pull the fan out from the engine compartment.
How do you remove a fan clutch on a 2002 Ford Explorer Sport Trac Truck?
To remove the fan clutch on a 2002 Ford Explorer Sport Trac, first ensure the engine is cool and disconnect the negative battery terminal. Next, use a wrench to hold the water pump pulley in place while you turn the fan clutch counterclockwise to loosen it. Once loose, carefully detach the fan clutch from the water pump shaft. Be cautious of any remaining coolant and ensure you have the necessary tools, as some fan clutches may require a special tool for removal.
How do you remove fan from 1993 ford econoline e150 4.9liter 6 cylinder?
You need to rent or buy a fan clutch removal tool kit. you need to remove the fan and clutch as one before you can separate the fan from the clutch.
How do you get the fan out to get to the water pump of a 1992 ford explorer?
It is a fan with a clutch. You have to have clutch wrentches to remove it. The nut that holds it to the water pump is an 1 1/2 nut. You have to hold the water pump pulley from turning and loosen the nut by turning it counter clockwise (as you are looking at it).
How do you remove fan clutch of a 1985 buick regal?
Remove the fan itself then remove the clutch from the fan
What would cause a roaring sound when the ac is on in a 1999 Ford Explorer?
Could be clutch cooling fan engaging
How do you remove the fan clutch on 1999 turbo diesel ford van?
by use of fan cluthc wrench ( air hammer)
How do remove the fan clutch on a 93 5.8L ford?
remove the bolts holding it to the water pump pulley, then wiggle the fan out under neath the radiator hose ( or take it off if you like) there will be 4 bolts on the front of the fan holding on the fan clutch. good luck!
