answersLogoWhite

0

What else can I help you with?

Related Questions

How do you remove a lock cylinder for a 1988 gmc jimmy?

if it is the ignition lock cylinder, first disconnect the battery, you need to remove the steering wheel ,turn signal switch , etc, then you need to insert the ignition key into the lock cylinder, turn it to the run position,then pull the cylinder out, reverse the operation to install the cylinder,


How do you replace the ignition lock cylinder on a 1994 GMC Jimmy S-15 with tilt steering?

take the steering wheel off, remove the safety plate and there's a small screw that is about the one 'o clock position on the column. take that out. also, get a manual...ah-ha!


How do remove the key cylinder in a 1998 gmc jimmy?

If you have the "PassLock" Security system on your vehicle, you MUST take it to the dealer to have the ignition changed out. The will have to reprogram the security system to match. If they don't your security may stay engaged which will cut of the fuel.


Replace alternator 97 jimmy?

disconnect neg bat terminal , remove belt , remove cables from alt. , remove bolts holding alt.


How do you replace ignition switch on 97 gmc jimmy?

Pull your steering colum apart along with steering wheel and dash plastic, ignition swith is next to the key tumbler. Swap the parts.


How do you replace the mirrors on a 95 gmc jimmy?

remove your door panel remove the rubbers grommets, remove 3 10mm nuts unplug if power, reverse process


How do you change the ignition switch on a 1996 GMC Yukon?

howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy


How do you replace the heater core on a jimmy?

How do you replace the heater core on a jimmy?


How do you check the operation of the fuel pump on a 2000 gmc jimmy?

being that fuel pump is in the gas tank I would remove the fuel line at the filter then turn on ignition being that fuel pump is in the gas tank I would remove the fuel line at the filter then turn on ignition


How do you replace a passenger side mirror on a 1998 jimmy?

you have to remove door panel and there are three nuts you have to take off of the mirror.


Gmc jimmy engine stops after dash lights flash?

I have been researching for a fix to get my dash lights working again and have come across your problem and the fix seems to be that you have to change the ignition switch which is a wire harness under the steering colum attached bellow the key cylinder. If you look up jimmy ignition switch you will find the info you need.


How do you replace the idler pulley on a 1999 GMC Jimmy?

remove serpentine belt center bolt in idler remove, and install new pulleyand rplace belt the way it came off