That depends on what brake lights you have. If you have the squared ones with the reverse lights built in, those covers are held in with screws. If you have the Truck Lite sealed lights, you don't take those off - you replace the entire unit.
How do you remove the brake light cover on a ford focus
how do you remove the brake light cover on a 1991 gmc tracker? Do you go from the outside or inside?
How do you remove cover to replace brake light on 57 kia Rio
On the brake pedal itself.
It's attached to the brake pedal arm.
Stuck brake light switch, or a short to power somewhere in the brake light circuit.
You can remove the ABS and brake light, from your Oldsmobile Alero, by removing the dash cover. The light retaining nut must be removed. The light will come out.
The brake light bald can be accessed through the trunk of the car. Remove the rear tail light cover to access the brake light bulb.
Remove the wiring harness from the high mount brake light. Remove the back cover of the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. Reverse the process to install the new brake light.
Should be to the left of the clutch pedal.
To replace the third brake light on a 2007 Toyota Avalon, first, open the trunk and locate the plastic cover that conceals the brake light assembly. Remove the cover by unscrewing or unclipping it, then disconnect the electrical connector from the old light assembly. Next, remove the old brake light by unscrewing or pulling it out, and install the new light by reversing the process. Finally, reconnect the electrical connector and replace the plastic cover.
there are two small bolts in your box on the side of the light