This answer is out of the 1965 Tempest shop manual 1. Disconnect wire from the tank gauge unit at the unit 2. Raise car and support fuel tank. 3. Drain fuel tank (siphon with a weighted length of hose) 4. Remove clamp connecting fuel line to tank. 5. Remove screws holding filler pipe bracket and seal to body. 6. Remove nuts securing support straps holding fuel tank to body. 7. Lower fuel tank from car. To install reverse above procedure.
It is inside the fuel tank, you have to drop the tank, and remove the sending unit, from the tank to replace the fuel pump.
yes
You must remove the fuel tank.
It is in the tank. Remove the tank then the pump. Not an easy job.
It is inside the fuel tank. You have to remove the entire tank to replace it. I just did mine and it cost $1350!
Not that I know of. The tank has to come down to gain access to the pump.
May have to remove fuel tank for access
It is mounted on the top of the fuel tank. Just remove it.
Answer try to run out the gas as much as u can !!You must remove the gas tank and then remove the pump and replace then reinstall the tank. This is not recommended for the inexperienced.
The fuel pump is located inside the fuel tank. You'll have to drain the fuel and drop the tank to get at the pump.
Put car on a lift, and drop the gas tank. on top is the gas lines coming out of tank, the pump is inside tank.
It might be in the gas tank. You'll have to remove the gas tank and switch it like that, then put it back on. in the fuel tank