0
What else can I help you with?
How do you fix the window pulley on a 2003 Pontiac Grand Prix?
You will have to replace the regulator assembly.
Can i replace my 2003 Toyota Echo antenna?
You can replace your 2003 Toyota Echo antenna. Remove the antenna retaining nut. Remove the cable from the bottom of the antenna. Reverse the process to install the new antenna.
How do you replace a brake light on a 2003 Toyota RAV-4?
Open trunk and remove screws that secure light assembly to car. Pull assembly straight back to remove from car. Remove the dead light and replace with proper new light. Install in reverse order of removal.
How do you replace the front wheel bearing on a 2003 Pontiac vibe GT?
Take off the steering knuckle and press out the bearing and hub.Have the new bearing pressed in with the hub and re install the knuckle.
How do you change the return filter on a 2003 Chevy Silverado?
To change the return filter on a 2003 Chevy Silverado is easy. Simply open the hood of your car and gently remove the filter and replace with new filter. that it!
How do you replace a turn signal switch for a 2003 Pontiac aztek?
To replace a turn signal switch on a 2003 Pontiac Aztek, also known as a flash relay, the steering column must be removed. The flash relay is located under the turn signal. Remove the mounting hardware and the unit can be taken off.
How do you replace the heater cor on a 2003 Pontiac aztek?
To replace the heater core on a 2003 Pontiac Aztek, first, disconnect the negative battery cable and drain the cooling system. Remove the dashboard and the center console to access the heater core housing. Disconnect the heater core hoses from the firewall, unbolt the heater core from its housing, and then replace it with the new core. Reassemble everything in reverse order, refill the cooling system, and check for leaks.
Gas mileage 2003 Pontiac aztek get?
23
How do you replace the thermostat on a 2002 Pontiac Aztek?
AnswerCould someone post directions on how to change the thermostat on a 2002 Pont. Aztek? Is it any different than a 2003?It shouldn't be any different....
How do you replace an alternator in a 2003 Pontiac aztek?
To replace the alternator you must tip the motor. by removing the motor mounts in front on the motor.just the two top ones and than roll the motor forward. that will give you enough room to remove the alternator
How do you disconnect the battery on a 2003 Pontiac Aztek?
by taking the cables out
What is the spark plug gap on a 2003 Pontiac Aztek?
.059
How do you replace an idle Air Control Valve on a 2003 Pontiac Aztek?
To replace the idle air control valve (IAC) on a 2003 Pontiac Aztek, first, disconnect the negative battery terminal to ensure safety. Locate the IAC valve on the throttle body, then remove the electrical connector and the mounting screws using the appropriate tools. Replace the old valve with the new one, secure it with the screws, and reconnect the electrical connector. Finally, reconnect the battery and start the engine to ensure proper operation.
How do you change the brake pads on a 2003 Pontiac Aztek?
To change the brake pads on a 2003 Pontiac Aztek, start by lifting the vehicle and removing the wheel. Next, remove the caliper bolts and carefully slide the caliper off the rotor, then remove the old brake pads. Install the new pads, ensuring they are properly aligned, and reattach the caliper. Finally, replace the wheel, lower the vehicle, and pump the brake pedal to ensure the pads seat correctly.
Where is engine coolant sensor located on a 2003 Pontiac aztek?
where do i find the low side service port on a aztek
Where is the fuel pressure sensor on a 2003 Pontiac Aztek?
On the fuel tank.
How many gallons does the tank in a 2003 Pontiac Aztec hold?
18 gallons found at http://www.new-cars.com/2003/pontiac/pontiac-aztek-specs.html
