0
on the side of the trans where the slave cylinder goes into the bell housing, there is a gold fitting attaching the hyd. line to the slave. on that gold fitting there is a white plastic band that needs to be pushed down towards the slave cylinder. push it in far enough and the line will pull free.
What else can I help you with?
How do you remove the hydraulic clutch cable from the transmission on a 93 Ford Ranger 5 speed trans?
The hydraulic clutch slave cylinder is located on the mainshaft of the trans. You must remove the trans to get to it
How do you remove the hydraulic clutch line from the slave cylinder on a 1992 ford ranger?
push in line pull back teflon sleeve evenly then pull back
How do you remove the fan clutch on a 2001 Ford Ranger?
you have to have fan clutch wrenches
How do you Remove clutch interlock switch on ford ranger?
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
How do you remove the hydraulic clutch line from the master cyliner on a 1986 Ford Ranger 2.3 l?
It's just a bolt on fitting, back it off counter clock-wise
How do you remove the clutch cable on a 1996 Chevy s10?
There is no cable, it is hydraulic operated.
How do you connect hydraulic hose to clutch slave of a 1992 ford ranger?
Just make it snug with an open end wrench and bleed the line to remove air (make sure fluid reserve does not get low while bleeding).
Where is slave cylinder on a 2000 Ford Ranger?
The slave cylinder on a 2000 Ford Ranger is located on the driver's side of the vehicle, mounted on the transmission, typically near the bell housing. It is connected to the clutch hydraulic system and is responsible for disengaging the clutch when the pedal is pressed. To access it, you may need to remove the transmission or work around other components in the engine bay.
How do you change the master cylinder on a hydraulic clutch on a 93 Chevy cheyenne 1500 pickup?
To change the master cylinder on a 1993 Chevy Cheyenne 1500 pickup with a hydraulic clutch, first, disconnect the negative battery terminal. Then, remove the clutch fluid reservoir cap and drain the fluid. Unbolt the master cylinder from the firewall, disconnect the push rod from the clutch pedal, and remove the hydraulic lines. Install the new master cylinder by reversing these steps, ensuring all connections are secure and refill the reservoir with the appropriate hydraulic fluid.
How do you change Astra clutch slave cylinder?
To change the Astra clutch slave cylinder, first, ensure the vehicle is securely lifted and supported. Begin by draining the hydraulic fluid from the clutch system and disconnecting the hydraulic line from the slave cylinder. Remove any mounting bolts securing the slave cylinder to the transmission, then take out the old cylinder. Install the new slave cylinder, reconnect the hydraulic line, and refill the clutch fluid, ensuring to bleed the system to remove any air before testing the clutch operation.
How do you replace clutch master cylinder for a Ford Probe 94'?
To replace the clutch master cylinder on a 1994 Ford Probe, first, disconnect the battery and remove the engine cover if applicable. Next, locate the clutch master cylinder on the driver's side, disconnect the hydraulic line and remove the retaining bolts. Install the new master cylinder by securing it with the bolts, reconnect the hydraulic line, and bleed the clutch system to remove any air. Finally, reconnect the battery and test the clutch operation.
How do you remove the hydraulic clutch cylinder 89 ford bronco II?
Remove the exaust pipes. Remove the transmission. It is located inside the bell housing section of the transmission.
