yes
Very carefully :)
The 1992 Mercedes-Benz 300 rear bumper is held in place with eight retaining bolts. You can remove the rear bumper by removing the retaining bolts.
To remove the front bumper cover on a 1998 Mercedes-Benz ML320, start by disconnecting the battery for safety. Next, remove any screws or bolts securing the bumper, which are typically located in the wheel wells and underneath the front of the vehicle. Carefully pull the bumper away from the body, ensuring to disconnect any electrical connectors for fog lights or sensors. Finally, lift the bumper off and set it aside.
As you look at the car from the front, it will be behind the bumper cover on the left. You must remove the entire bumper to access it.
To remove the rear bumper from a Mercedes W126, first, ensure the vehicle is securely positioned on flat ground. Begin by removing the screws and bolts located under the bumper, typically found near the mounting points on each side. You may also need to detach any clips or wiring connected to the bumper. Once all fasteners are removed, gently pull the bumper away from the vehicle, being careful not to damage any surrounding components.
You will have to go between front bumper and under the wheel plastic reflector, you will not have to remove any of them, if you lay down on the ground you can reach bulb socket and turn counterclockwise it will lose them up replace bulb with proper one and install it back turning clockwise
You have to remove the front bumper to gain access to sensors.
how to remove 2013 passat rear bumper
4 13mm bolts, 2 clips. remove licence plate, 2 bolts there, remove plugs near steps, 2 bolts there. slide ends off clips.
4 13mm bolts, 2 clips. remove licence plate, 2 bolts there, remove plugs near steps, 2 bolts there. slide ends off clips.
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.