To change the power steering pump on a 1998 Isuzu Rodeo, first, disconnect the negative battery terminal and drain the power steering fluid. Remove the serpentine belt by loosening the tensioner, then detach the pump's hoses and mounting bolts. Install the new pump by reversing the removal process, ensuring all connections are secure, and refill the power steering fluid before testing the system for leaks.
To replace an Isuza Rodeo steering the steering column should first be removed. Pop off the front steering wheel cover to see the steering wheel nut. Loosen the nut and remove the wheel.
Most power steering fluid is the same, only different brand names. Call your local Isuzu dealer if you are not sure.
First you will need to remove the steering column cover which will expose the ignition switch. Remove the connector and the three bolts holding it on. Pull the switch out and replace.
sounds like a bad power stearing pump
If you are refering to the A/C compressor, it is under the power steering pump, on the right side of the engine, while facing it.
The guy at the local transmission repair shop told me it sits on top of the engine control module. You have to remove the console to get to it.
Did you check the drive belt to see if it broke?
On a 1994 Isuzu Rodeo, the Engine Control Module (ECM) is typically located under the dashboard on the driver's side. It is mounted above the accelerator pedal area, near the steering column. You may need to remove a cover or panel to access it. Always ensure the vehicle is turned off and take necessary precautions when handling electronic components.
how do you remove transmission in 1999 rodeo
Mine is located on the steering wheel . press the lower portion of the wheel . i have the 1997 holden rodeo .
3; alternator, power steering, air conditioner... There is the timing belt also. It is behind some covers at the front of the engine.