answersLogoWhite

0

You have to remove the entire door panel. There are a few screws (phillips) that need to be removed as well as the push pins on the outer perimeter of the panel. Once the panel is separated from the door, you will need to disconnect the door handle by removing the rod that is attached. Disconnect the wiring harness for your windows/locks and disconnect the wire on the back of the courtesy light at the base of the panel. After that, you will see the four screws that hold the actual 6x9 speaker in place. Remove those and disconnect the wiring.

A few other thoughts...some reference charts will tell you that you can get a 5" deep 6x9 for the door but they don't clarify. If you buy an aftermarket speaker, the magnet diameter is significantly larger and interferes with the vertical beam inside the door. Just keep that in mind in your speaker shopping and don't buy the high powered 6x9 unless you're prepared to do a custom installation. My recommendation would be to get an original Boston that you know will fit it (and the wiring is already there) and be done with it.

User Avatar

Wiki User

14y ago

What else can I help you with?