It depends on what you mean by computer. The '88 bronco has an TFI control module mounted on the distributor. It is held on by 2 Phillips screws and should be relatively easy to take off without removing the distributor.
It is on the driver side of the engine block next to the power steering pump.
most likely a c6 3spd
I believe that is a version of the C6 - 3 speed automatic transmission
remove batt. cable from starter(its not wired to batt so has no power) remove 2 1/2 bolts remove starter
Well you take out the tail light assem and remove the blown bulb
No , the 1972 Ford Bronco is a full size vehicle
my 86 full size bronco haha
There is the FULL SIZE BRONCO and then the Bronco II ( the Bronco II is smaller , eventually replaced by the Ford Explorer)
More than likely it is a C-6.
I have a 1988 Full Size bronco. The fuel filter for it is on the drivers sde frame rail just about directly below the gas pedal. Careful when you take it off cuz it's under pressure and you'll get sprayed with fuel
The average weight of 1993 full size xlt bronco is 6,300 lbs
Go here.Can_you_remove_the_roof_off_of_a_1994_bronco_and_how_do_you_do_it These directions are for a 92-96 model, but the steps are basically the same for all other full size models.