0
Remove wheels
remove caliper mounting bolts
Slide caliper off rotor
a special tool (not expensive available at Sears or auto parts) is needed to fully retract piston into caliper body (it is threaded)
Replace inner and outer pads
PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
What else can I help you with?
I have a 1993 Mazda protoge dx and was told the horn relay is bad where is it located and the haynes repair book wasn't any help at all?
I have a 1993 Mazda Protege LX and I was told that there is no relay for the horn, there is a horn switch inside your steering wheel. that might help
How do you change heater core on 93 Mazda protoge?
Replacement of the heater core on a 1993 Mazda Protege is going to first require the removal of the entire dashboard. Once that is removed then the heater control box will need to be removed and disassembled in order to get access to the heater core inside.
I can't remove my old oil filter in my 1993 Mazda Protege. There's not enough leverage and space to turn it with a tool. How do I remove it?
get the proper one for a Mazda
How do you replace the heater core on a 1993 Mazda 929?
you have to remove the dash and every thing attached to it. Is it the same for a 1988 Mazda 929?
How do you get a key out of an ignition of a 1993 Mazda protege it is stuck and you cant even start it or remove the key?
i have no clue i have the same problem with my Mazda 1999 626
How do you change the brakes and rotors on a 1993 Chevy Lumina?
Remove the tire and wheel from your 1993 Chevy Lumina. Remove the brake assembly spring and the brake caliper. The brake assembly will come off. Tap on the rotor with a hammer or mallet. The rotor will slide off. Reverse the process to change the new rotor and brakes.
Where is flasher unit in Mazda 323 Astina 1993?
The flasher unit on a Mazda 323 is located on the end of the flasher lever. Remove the lower steering column to bring the unit to view.
How do you remove and replace a 1993 Mazda b2600 clutch assembly?
Go read the instructions, unless you're too MAN enough to do it.
How do you tell if the starter or the flywheel ring is bad on a 1993 Mazda 626 lx?
Remove the starter and inspect the ring gear on the flywheel.
How do you remove the lens to change the headlamp on my 1993 Mazda 929?
To remove the lens and change the headlamp on your 1993 Mazda 929, first, open the hood and locate the headlamp assembly. Remove the screws or clips holding the assembly in place. Once loose, gently pull the headlamp assembly forward, disconnect the electrical connector, and then replace the bulb. Reassemble by reversing the steps, ensuring everything is securely fastened.
How do you remove crankshaft pulley Mazda 626 1993?
Im not sure which direction the bolt turns to remove the pulley...the crank shaft turns in clock wise direction when engine is running.
What kind of rear brakes does a 1993 Ford Aerostar have?
You have drum brakes on the rear.
